User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The front board
- 3.3 The input/output board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit switch
- 3.6 Configuration information
- 3.7 Terminal with third-party OSDPv2 read head
- 3.8 Terminal with third-party Wiegand read head
- 3.9 Terminal with DIU 230 and third-party Wiegand read head
- 3.10 Configuration information
- 3.11 S700e with S700s exit reader
- 3.12 S700 with DIU 210 and S700s exit reader
- 3.13 S700 terminal with DIU 230
- 3.14 Tamper detection on reader inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- S700 Operational Modes
- Appendix 1 Updating Firmware
- Appendix 2 Broadcast and Timezone Priorities
- Appendix 3 Loading card definitions
S700 Installation Manual
57
10. If an exit reader has been added by including it in the Device Type, enter a unique Slave
Location to describe the location of the exit reader.
11. Select the Settings tab. Enter the unique MAC Address or IP Address of the device into
the relevant fields.
The unique address of the device is found by navigating from the Configuration Menu to
the Network Status menu on the S700 itself.
12. Select the Offline Database drop-down list and select one of the following two options for
the device:
i. Card Number
ii. Card Number, Timezone, Status, PIN
13. Click Save. This adds the device to the AC2000 system.
Note: Threat groups are only used if threat levels have been activated on AC2000. For further
information, see the AC2000 Threat Levels manual.
5.2.1 Configuring a third-party read head
To configure the Slave to be a third-party read head only, complete the following steps:
Note: Following the instructions, Adding the device to AC2000 on page 56, a Slave is added
to a master reader. The master reader configured the exit reader by default.
1. Log on to the AC2000 Floatbar, click Device Configuration, and click Devices.
Figure 35 Third-party read head configuration
2. Select the device, with associated exit reader, to be configured.
3. Select the Properties tab.
Properties contains the most commonly used tabs. To access more specialised tabs, click
Advanced View.
4. Select Slave Settings from the list in the Properties pane.
5. In the Slave Settings pane at the bottom of the interface, ensure the Slave reader
enabled check box is clear.
Configuration tabs
Properties tab
Selected
device and
associated
exit reader
Exit
reader
settings