User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The front board
- 3.3 The input/output board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit switch
- 3.6 Configuration information
- 3.7 Terminal with third-party OSDPv2 read head
- 3.8 Terminal with third-party Wiegand read head
- 3.9 Terminal with DIU 230 and third-party Wiegand read head
- 3.10 Configuration information
- 3.11 S700e with S700s exit reader
- 3.12 S700 with DIU 210 and S700s exit reader
- 3.13 S700 terminal with DIU 230
- 3.14 Tamper detection on reader inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- S700 Operational Modes
- Appendix 1 Updating Firmware
- Appendix 2 Broadcast and Timezone Priorities
- Appendix 3 Loading card definitions
S700 Installation Manual
71
Table 29: Database status describes the fields in the Database status information window:
Network Settings: key 5
The Network Settings section contains information the installer uses to configure the terminal
network settings.
Figure 46 Network Settings
Sound Settings: key 6
Use the Sound settings menu to change the volume of the internal speaker on the terminal.
Information Description
CS Count The number of card records with which the local database
was initialized
CS Time This is the time the local card database was last initialised
DB Format This shows the database format
DB Count This is the current number of valid cards in the local
database
DB update This shows the time of the last database update
DB state This shows the database state
Off events This is the number of offline buffered event waiting to be
uploaded to the server
Table 29: Database status
Subnet mask
displays the
address of
the network
to which the
terminal is
connected
Gateway
displays the
IP address of
the gateway
server -
where it is
appropriate
IP address
displays the
IP address
assigned to
the terminal