User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The front board
- 3.3 The input/output board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit switch
- 3.6 Configuration information
- 3.7 Terminal with third-party OSDPv2 read head
- 3.8 Terminal with third-party Wiegand read head
- 3.9 Terminal with DIU 230 and third-party Wiegand read head
- 3.10 Configuration information
- 3.11 S700e with S700s exit reader
- 3.12 S700 with DIU 210 and S700s exit reader
- 3.13 S700 terminal with DIU 230
- 3.14 Tamper detection on reader inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- S700 Operational Modes
- Appendix 1 Updating Firmware
- Appendix 2 Broadcast and Timezone Priorities
- Appendix 3 Loading card definitions
S700 Installation Manual
77
3. From the main panel, select the timing you want to amend. This panel is shown in the
following figure. Update the value you require in seconds.
Figure 51 Updating the door cycle timings
Door mode is the default terminal configuration that is described in the main installation section
of this manual. Use door mode to allow a terminal to control access to a door and monitor
specific inputs associated with that door.
7.1.1 Multi-swipe access
The S700 terminal can be configured to require swipes from up to five valid cards before
granting access. Configure this using the Devices application. When this setting is configured,
an initial valid swipe prompts a request for further valid swipes on the screen before opening
the door. When all valid cards are swiped the terminal grants the user access.
Figure 52 Multi-swipe request screen and access granted screen
The multi-card request swipe screen shows the number of valid cards required to grant
access, up to a maximum of five cards. As each valid card is swiped, the S700 reader
increments the card values shown in the card count display section and access is granted.
Software configuration for multi-swipe access
To activate multi-swipe access mode, complete the following steps:
1. Log on to the AC2000 Floatbar, click Device Configuration, and click Devices.
2. Select the terminal you want to configure.
3. Select the Properties tab and click Advanced View.