User's Manual

S700 Installation Manual
81
Adding special access to a cardholder
To add special access to a cardholder, complete the following steps:
1. Log on to the AC2000 Floatbar, click Enrolment, and click Personnel.
2. Search for the cardholder to which the special access is to be applied.
3. Select the Special Usage check box.
4. Click Save.
7.2.2 The passenger mode cycle
Table 31: Illustration of passenger mode timing outlines the door open cycle. The passenger
mode cycle is located within that cycle; it is only available to the system if Passenger mode is
selected.
Table 31: Illustration of passenger mode timing
To activate passenger mode on a terminal, complete the following steps:
1. To give a cardholder the ability to use the door in Passenger mode, you must go to their
Personnel record on the AC2000 system. When you locate their record using the
Personnel application, select the Special Usage check box. When the check box is
selected, Passenger mode is activated for those cardholders who swipe their access cards
on this terminal.
2. The terminal asks the cardholder if they require Passenger or Staff. Click the left function
key for Passenger and the right function key for Staff. Selecting staff access causes the
terminal to act as in Door Mode.
Lock output
Lock Open
Time
Lock Open Time
Normal open
Door close after
Sounder
warning,
legal open
time
running out
Pre-alarm
Allowing time
to close
Close time
Door held
alarm and
alarm
sounder
Alarm Time
Notes If the door is not
detected
open before
the Lock
Open Time
period
expires, the
lock is re-
secured and
the door
mode returns
to the idle
state
The door has
been
detected
open
If the door is
detected
closed before
the Door
close after
period, the
Lock Open
Time 2 is
cancelled
and the door
mode returns
to the idle
state
The pre-alarm
starts the
defined
second
before Door
close after
expires
Close Time
is to allow
an
automatic
door time
to close
when the
cycle is
complete;
the pre-
alarm
continues
during the
Close
Time