User's Manual

AC2000 Getting Started Guide
21
3.8 Configuration information
The emerald terminal facilitates the use of a third party exit Wiegand head with three LEDs.
Supported third party read heads
CEM support the use of HID R10 heads for reading Mifare and iClass cards.
Note
The sounder functionality of third party read heads is not supported.
Typical Wiegand read head wiring
For specific read head wiring consult the third party manufacturer.
Important
For proper regulatory compliance, the drain wire should be disconnected at the power supplied end of the cable.
Input configuration
The table below illustrates the configuration and operation of the inputs on the terminal when
configured with a third party Wiegand read head.
Note
To configure a Slave reader as the Master reader, refer to the Appendix on page 85.
Product CEM Product Code
HID iClass SE R10 SmartCard Reader HDS/053/010
HID iClass SE R30 SmartCard Reader HDS/053/030
HID iClass SE R40 SmartCard Reader HDS/053/040
Table 11: Read head product code
I/O board connection Typical HID colour
GND Black
Sounder Not Supported
Green LED Orange
Amber LED Not fitted
Red LED Brown
Data 1 White
Data 0 Green
Head 12V Red
Table 12: Typical Wiegand head wiring
Input number Input function Default input trigger state change
0 Door position short => open
1 Lock position short => open
2 Request to exit switch open => momentary short => open
3 Spare / Interlock short => open
Table 13: emerald and 3rd party read head input configuration