User's Manual

A2SE67-UG-0011-1
CHAPTER 5 : AC2000 Software Configuration
38
5.2 Adding the device to AC2000
1. From the AC2000 Floatbar open Device Configuration | Devices.
2. Select the controller and device group to which the device is to be added.
3. Right click the device group and select Add Device.
Figure 29 The add device dialogue with example terminal information
4. Select the Device Type TS100, TS200 or TS300 from the drop down menu.
1
5. Select the Configuration Mode TS 100/200/300 from the dropdown list.
2
6. Select a Device Number for the device.
7. Enter a unique Device Location description for the device
8. Where a slave device has been included in the Device Type, enter a unique Slave
Location description for the Slave device.
9. Enter the unique Mac Address of the device.
– This is found in the System information | Network on the emerald terminal.
10. Enter the unique IP address of the device.
11. Click Add. The terminal is now added to the AC2000 system.
Note
Threat groups are only used if threat levels have been activated on AC2000. For further
information consult the AC2000 Threat Levels manual.
1.If an exit or auxiliary device is added to the master reader, ensure to select the correct type, i.e. A
TS100 device with an Exit Reader would have a Device Type of TS100+Slave. This will configure
the Master device with an attached slave device.
Any exit reader added to a master will appear as a child node in the Overview Pane of the mas-
ter reader it is associated with.
2.The configuration mode contains default settings, however these can be user defined. To create a
configuration mode refer to the AC2000 User Guide.