User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The Front Board
- 3.3 The Input/Output Board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit Switch
- 3.6 Configuration information
- 3.7 Terminal with 3rd Party Wiegand Read Head
- 3.8 Configuration information
- 3.9 Terminal with S610s Exit Reader
- 3.10 Terminal with DIU 210
- 3.11 Terminal with DIU 230
- 3.12 PoE+ Terminal with S610s Exit Reader
- 3.13 Tamper Detection on Reader Inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- Door Modes
- Appendix II: Device Settings Remote Application
- Appendix III: Broadcast and Timezone Priorities
- Appendix IV: Loading Card Definitions
- Appendix V: Configuring a Third Party Reader as a Master
AC2000 Getting Started Guide
65
7.4.2 The interlock process in door mode
Interlock is configured and works the same way in Passenger Mode and Door Mode, with
only a slight change to end functionality.
7.4.3 The interlock process in passenger mode
1. The spare outputs of terminals are linked to input 3 of the other interlocked terminals.
2. When input 3 of the terminal is closed the terminal remains idle.
3. When a valid card is swiped at an interlocked terminal, both outputs on the terminal
change to the open state. This drops lock power at the swiped terminal and simultaneously
opens input 3 on any interlocked terminals.
Figure 57 Interlock locked down display
message in door mode
1. The spare outputs of terminals are linked to
input 3 of the other interlocked terminals.
2. When input 3 of the terminal is closed the
terminal remains idle.
3. When a valid card is swiped at an interlocked
terminal, both outputs on the terminal change
to the open state. This drops lock power at the
swiped terminal and simultaneously opens
input 3 on any interlocked terminals.
4. Interlocked terminals lock down and display
the lockdown message.
5. The interlock function ends when the original
swiped door is closed.
Figure 58 Passenger mode
countdown on the swiped
terminal
4. The swiped terminal displays a countdown screen
showing the time that the doors will remain interlocked.
(Passenger time in the Devices application)