User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The Front Board
- 3.3 The Input/Output Board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit Switch
- 3.6 Configuration information
- 3.7 Terminal with 3rd Party Wiegand Read Head
- 3.8 Configuration information
- 3.9 Terminal with S610s Exit Reader
- 3.10 Terminal with DIU 210
- 3.11 Terminal with DIU 230
- 3.12 PoE+ Terminal with S610s Exit Reader
- 3.13 Tamper Detection on Reader Inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- Door Modes
- Appendix II: Device Settings Remote Application
- Appendix III: Broadcast and Timezone Priorities
- Appendix IV: Loading Card Definitions
- Appendix V: Configuring a Third Party Reader as a Master
AC2000 Getting Started Guide
69
The next time that a card is swiped on the reader which has had the Image on Swipe function
activated, the image associated with that card will display on the emerald screen. Tapping the
green tick on the screen indicates that the image on screen resembles the cardholder and
access is granted. Tapping the red X indicates that the image does not resemble the
cardholder and access is denied.
Figure 62 Image on Swipe display on screen
Viewing cardholder details
There are several options available for viewing the cardholder information on the emerald
screen. Use a sequence of tapping the image to view the information as described below:
• To view the image and cardholder details, tap the image once
• To view a smaller image and a larger text display, tap the image twice
• To view a larger image and minimal text display tap the image three times
• To view more cardholder details in the list below the image, press and hold your finger on
the screen and drag the text area in a scrolling motion