User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The Front Board
- 3.3 The Input/Output Board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit Switch
- 3.6 Configuration information
- 3.7 Terminal with 3rd Party Wiegand Read Head
- 3.8 Configuration information
- 3.9 Terminal with S610s Exit Reader
- 3.10 Terminal with DIU 210
- 3.11 Terminal with DIU 230
- 3.12 PoE+ Terminal with S610s Exit Reader
- 3.13 Tamper Detection on Reader Inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- Door Modes
- Appendix II: Device Settings Remote Application
- Appendix III: Broadcast and Timezone Priorities
- Appendix IV: Loading Card Definitions
- Appendix V: Configuring a Third Party Reader as a Master
Configuring the options . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 76
Appendix II: Broadcast and Timezone Priorities. . . . . . . . . . . . . . . . . . . . . . . . . . . 81
Appendix III: Loading Card Definitions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 83
Appendix IV: Configuring a Third Party Reader as a Master . . . . . . . . . . . . . . . . . 85
Appendix V: User Defined Logo. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 87
Licensing the emerald logo change function . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 87
Enabling the emerald logo change function on the CDC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 88
Uploading a user defined Card Logo in AC2000 WEB. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 88