User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The Front Board
- 3.3 The Input/Output Board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit Switch
- 3.6 Configuration information
- 3.7 Terminal with 3rd Party Wiegand Read Head
- 3.8 Configuration information
- 3.9 Terminal with S610s Exit Reader
- 3.10 Terminal with DIU 210
- 3.11 Terminal with DIU 230
- 3.12 PoE+ Terminal with S610s Exit Reader
- 3.13 Tamper Detection on Reader Inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- Door Modes
- Appendix II: Device Settings Remote Application
- Appendix III: Broadcast and Timezone Priorities
- Appendix IV: Loading Card Definitions
- Appendix V: Configuring a Third Party Reader as a Master
TSR-IM-0045-1.6
74
Figure 65 Selecting devices to defrost
A message will appear similar to the following:
Initiating defrost to device:XXXX with firmware file:<filename>
Updating the terminal
Once the terminal has received the firmware file, the reader address will be displayed in cyan
instead of white.
Figure 66 Cyan reader address
1. Access the terminal System Configuration menu.
2. Open Device settings | Options.
3. Press Upgrade.
Figure 67 Upgrading the terminal firmware
The reader will update and reboot.
Note
The reader will go offline momentarily whilst the upgrade takes place.
Select the firmware image
Select the device type to be
defrosted. This should match the
firmware file type
Select the devices to be defrosted.
Hold Ctrl + click multiple devices if
required.
Ensure that the selected devices
are of the correct type.
Click defrost to complete the process
Reader address
displayed in cyan