User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The Front Board
- 3.3 The Input/Output Board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit Switch
- 3.6 Configuration information
- 3.7 Terminal with 3rd Party Wiegand Read Head
- 3.8 Configuration information
- 3.9 Terminal with S610s Exit Reader
- 3.10 Terminal with DIU 210
- 3.11 Terminal with DIU 230
- 3.12 PoE+ Terminal with S610s Exit Reader
- 3.13 Tamper Detection on Reader Inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- Door Modes
- Appendix II: Device Settings Remote Application
- Appendix III: Broadcast and Timezone Priorities
- Appendix IV: Loading Card Definitions
- Appendix V: Configuring a Third Party Reader as a Master
emerald TS100/200/300 Installation Manual
79
Workstation group
The workstation group option is used to assign an intercom workstation group to the terminal.
The terminal intercom function can only communicate with workstations assigned the same
workstation group number.
Figure 78 Configuring the workstation number setting
Pre Door Mode
The Pre Door Mode option is used to enable/disable Pre Door Mode functionality for the
terminal, including Image on Swipe.
indicates that the setting is enabled
X indicates that the setting is disabled
Figure 79 Configuring the Pre Door Mode setting
Current workstation
group number
Adjust the workstation
group by tapping the
plus and minus buttons
Tap to enable/disable Pre
Door Mode options
Tap to enable/disable
Image on Swipe mode
on the terminal