User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The Front Board
- 3.3 The Input/Output Board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit Switch
- 3.6 Configuration information
- 3.7 Terminal with 3rd Party Wiegand Read Head
- 3.8 Configuration information
- 3.9 Terminal with S610s Exit Reader
- 3.10 Terminal with DIU 210
- 3.11 Terminal with DIU 230
- 3.12 PoE+ Terminal with S610s Exit Reader
- 3.13 Tamper Detection on Reader Inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- Door Modes
- Appendix II: Device Settings Remote Application
- Appendix III: Broadcast and Timezone Priorities
- Appendix IV: Loading Card Definitions
- Appendix V: Configuring a Third Party Reader as a Master
TSR-IM-0045-1.6
86
3. Once the device is added, select it from the list and open the Configuration panel.
4. Open the Common panel.
Figure 82 Setting slave as master reader
5. Select Slave settings from the panel list.
6. Check the option Use Slave as Master.
Note
If Use Slave as Master does not appear in the Options pane, please contact CEM Support to
obtain the relevant CDC patch file, which after application, will cause the Use Slave as Master
option to be displayed.
7. Click Save to save all changes made.
Configuration
panel
Common
panel
Slave
settings
Save
Use Slave
as Master
checkbox