User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The Front Board
- 3.3 The Input/Output Board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit Switch
- 3.6 Configuration information
- 3.7 Terminal with 3rd Party Wiegand Read Head
- 3.8 Configuration information
- 3.9 Terminal with S610s Exit Reader
- 3.10 Terminal with DIU 210
- 3.11 Terminal with DIU 230
- 3.12 PoE+ Terminal with S610s Exit Reader
- 3.13 Tamper Detection on Reader Inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- Door Modes
- Appendix II: Device Settings Remote Application
- Appendix III: Broadcast and Timezone Priorities
- Appendix IV: Loading Card Definitions
- Appendix V: Configuring a Third Party Reader as a Master
A2SE67-UG-0011-1
User Defined Logo
88
Enabling the emerald logo change function on the CDC
To enable the integration on the CDC:
5. Open an interface with the server, by either:
i. Remotely opening a SSH terminal emulator connection (such as Putty) with the CDC.
ii. Or, directly accessing the CDC console.
6. Login as user: root
7. Type I in the command line and press return to display the Integrations menu.
Figure 86 Integrations menu in a terminal emulator
8. Type the option number corresponding with emerald Logo Change (21 in the example
displayed in Figure 86) and press Return.
9. Press Return when prompted, to display the integrations menu again.
10. Type X and press Return to exit integrations menu.
11. Type L and press Return to log out of terminal emulator session.
Uploading a user defined Card Logo in AC2000 WEB
12. Log in to AC2000 WEB.
13. Select emerald Configuration | File Upload.
14. From the main File Upload page select the file Type as DISPLAY.
Figure 87 Creating a user defined logo
15. Select a Group from the list. For more information on Groups, see Creating a Group in
the AC2000 WEB manual.
File Type
Group
Edit
Groups
Add
Content