User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The Front Board
- 3.3 The Input/Output Board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit Switch
- 3.6 Configuration information
- 3.7 Terminal with 3rd Party Wiegand Read Head
- 3.8 Configuration information
- 3.9 Terminal with S610s Exit Reader
- 3.10 Terminal with DIU 210
- 3.11 Terminal with DIU 230
- 3.12 PoE+ Terminal with S610s Exit Reader
- 3.13 Tamper Detection on Reader Inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- Door Modes
- Appendix II: Device Settings Remote Application
- Appendix III: Broadcast and Timezone Priorities
- Appendix IV: Loading Card Definitions
- Appendix V: Configuring a Third Party Reader as a Master
emerald TS100/200/300 Installation Manual
89
16. Click ADD CONTENT.
Figure 88 Uploading a logo
17. Click Browse.
18. Locate the required file and click Open.
Note
The image must be in PNG format. The recommended size is 287 pixels high by 143 pixels
wide and the maximum file size is 90kB.
19. Click UPLOAD.
20. Type a name for the logo in the content name field.
21. Click OK.
Figure 89 Verifying logo is uploaded
Upload
Browse to
file
Return to previous page
Logo
uploaded
successfull
Send logo