DOL1000-MF2 (2 Relay) Programming & Installation Manual
INTRODUCTION The DOL1000-MF2 is a versatile keypad that has the option of running wirelessly. The DOL1000- MF2 can work with 6 volts of battery power or 6-24 volts of AC/DC. This keypad can be wired with multiple wireless transmitters. DOL1000-MF2 can store up to 1000 access codes. Guest access codes are also programmable, which are single-use codes for access.
The very first time that you apply powewr to the keypad, you will hear a series of beeps followed by a regular repeating beep (1 beep at 3 second intervals) that lets you know you are in programming mode: Enter a 4 digit Master Code that only you will use for programming purposes. Write Master Code here You can now add up to 1000 access codes as well as a flash code (for one use only) and a latch code to hold open the gate.
PROGRAMMING THE DOL1000-MF2 with 433 MHz Module Default Master Code: 1 2 3 4 1 2 3 4, 1#, Access Code: __ __ __ __ , Channel:1 # Example: Add Access Codes STEP 1: Press 1 2 3 4 STEP 2: Press 1 # STEP 3: Enter access code __ __ __ __ STEP 4: Press 1 # (multiple beeps confirm) STEP 5: Press * * STEP 6: Test new access code. __ __ __ __ (Green light will flash 6 times confirming that the new access code has been accepted.
INSTALLING THE 433 MHz MODULE STEP1: Prepare the 433 MHz module STEP2: Remove (cut) the battery connector Antenna + Activation Wires: Common & Normally Open STEP 3: Install the 433 MHz Module to the keypad board Channel 1 Channel 2 • NOTE: Be sure to connect the power source to the correct terminals! The battery terminals and the AC/DC terminals are different. • NOTE: Any channel can be assigned for devices that connect to normally open/normally closed.
DIP SWITCH MODULE INSTALLATION EXAMPLE: Relay 1 Relay 2 NOTE: Be sure to connect the power source to the correct terminals! The battery terminals and the AC/DC terminals are different.
DIP SWITCHES 1. 2. 3. 4. 5. 6. SOUND LED LIGHTS Not used Not used WIRELESS MODE a. Switching this dip switch to off will enable the toggle gate feature and switching to the on position will disable the toggle gate feature. Disabling this feature can potentially save battery power in the case that the toggle gate feature has been accidentally activated. Refer to the programming chart for more details with the toggle gate feature. 7. Not used 8.
