User's Manual

Figure 5

Power Up

1. After all wiring is complete and the unit face plate is attached to the back plate,

apply 12Vdc power to the unit. Accept LED(the yellow LED) flashing.

Engineer Programming Mode

To enter programming mode

Press: * 9999 # within 5 seconds, Ready(the green LED) and Accept LED

illuminated, Open LED flashing.

Note

Press: # to save changes and exit engineer programming, when all programming

has been completed otherwise changes will not be saved.

Changing Master & User Codes

In engineer programming mode:

To change Master code

Press: 0 new master code # re-enter new master code #