User's Manual

Upon acceptance Open LED illuminates and stops flashing. Press * after

changing the master code, otherwise unit will disregard the new code and revert back

to the factory default code.

Note: the master code must be 4-8 digit number.

Adding User Codes & Cards

To Add User cards & codes

Press: 1 read card user identification #

Note: the user identification must be 3 digit number, if adding more than 1 card, read

the next card after inputting the 3 digit code for the previous card, when you have

finished adding all cards press the # key. 1

card must be 000 up to 999.

Then the SAM-1000 control station added a user card it was auto added a user code

with 1234.

Delete User Card or Cards

There are 3 options to delete a user card or cards, in engineering mode.

a.) Press: 2 0 0 0 0 # to delete all user cards

b.) Press: 2 read card # to delete individual user card

c.) Press: 2 user identification number # to delete individual user card

User Operation Mode

There are 3 different options for user operation mode, card only, card and password,

valid code. The optioned used is common to all users.

Press: 3 0 0 # valid card only

Press: 3 0 1 # valid card and password

Press: 3 0 2 # valid card or password

Setting Door Relay Strike Time

The door relay output can be operated as either normally opened or normally closed,

a maximum current of 10 ampere can pass through the relay if used as normally

opened or 5 ampere if normally closed. The door relay time can be set from 0

seconds to a maximum of 99 seconds. The factory default setting is 6 seconds and

can be changed through the keypad.

Press: 4 new time from 00-99 seconds #

Setting Alarm Signal Output Time

Press: 5 new time from 00-99 minutes #

Setting Door Open Detection