User Manual

10
Wiegand Mode
Wiegand Format Setting
SK1-H supports Wiegand 26~37, both input and output. It can be used as a reader or
controller.
To Set Wiegand format:
9 26~37 # (Default setting: Wiegand 26)
Pass through mode (SK1-H operating as a Wiegand Output Reader)
In this mode the SK1-H supports a Wiegand 26~37 bit output so the Wiegand data lines can be connected to
any controller which supports a Wiegand 26~37 bit input, then the SK1-H will be operated as a slave reader.
Wiring Diagram
Transmission Format:
Keypad Transmission
The Reader will transmit the PIN data when it receives the last key (#) press after PIN code.
Format: PIN Code (any 4~6 digits between 0000~999999)
Example: PIN code: 123456
Press 123456 #, then the output format will be: 0000123456
(Note: if press an invalid PIN (any 4~6 digits), the data will be also transmitted.)
Proximity Card Transmission
The Reader will transmit the card data when it reads the Card.
Format: Card Number
(Note: no matter the card is valid or invalid, the data will be transmitted)
Controller Mode (SK1-H operating as a Controller)
SK1-H supports a Wiegand 26~37 bit input so an external Wiegand device with a 26~37 bit output can be