User Manual

SK1-H- Simplified Instruction

Function Description Operation

Enter the Programming Mode * (Master Code) #

(666666 is the default factory master code)

Change the Master Code 0 （ New Master Code ）

（ Repeat New Master

Code）#

(code: 6 digits)

Add Card User 1 (Read Card) #

Add PIN User 1 (User ID) # (PIN) #

The ID number is any number between 1 ~ 1000. The

PIN is any 4-6 digits between 0000 ~ 999999

Delete User 2 (Read Card)

2 (User ID) #

Exit from the programming mode *

How to be granted access.

Card User Read card

PIN User Enter (PIN) #

FCC STATEMENT:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

This device may not cause harmful interference, and

This device must accept any interference received, including interference that may cause undesired

operation.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could

void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation.

This equipment generates uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications. However, there

is no guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.