User Manual

6
Standalone Operation
1.1 User Settings
To enter the programming mode
* Master code #
666666 is the default factory master code
To exit from the programming mode
*
Note that to undertake the following programming the master user must be logged in
To change the master code
0 New code # New code #
The master code is any 6 digits
Setting the working mode:
Set valid card or PIN users
Set valid card and PIN users
Set valid card only users
3 0 # Entry by either card or PIN (default)
3 1 # Entry by card and PIN together
3 2 # Entry by card only
To set a user in either card or PIN mode ( 3 0 # ) (Default setting)
To add a PIN user
1 User ID number # PIN #
The ID number is any number between 1~1000. The PIN is
any 4~6 digits between 0000~999999 with the exception
of 1234 which is reserved. Users can be added continuously
without exiting from programming mode as follows:
1 User ID no 1 # PIN # User ID no 2 # PIN #
To delete a PIN user
2 User ID number #
Users can be deleted continuously without exiting
programming mode
To change the PIN of a PIN user
(This step must be done out of programming
mode)
* ID number # Old PIN # New PIN #
New PIN #
To add a card user (Method 1)
This is the fastest way to add cards using ID
number auto generation.
1 Read card #
Cards can be added continuously without exiting
programming mode
To add a card user (Method 2)
This is the alternative way to add cards using
User ID Allocation. In this method a User ID
is allocated to a card. Only one user ID can be
allocated to a single card.
1 ID number # Card #
To add card user (Method 3)
Add a series cards users – Block Enrollment
5 ID number # The 1
st
Card number #
Card quantity #
Note that cards must be consecutive, and card quantity is
between 1~1000.