User Manual

ManualsBrandsControlled Entry Distributors ManualsElectronicsAccess Control

Maximum 1,000 cards can be enrolled at a stretch within 1

minute.

To delete a card user by card

Note users can be deleted continuously

without exiting programming mode

2 Read Card #

To delete a card user by user ID

This option can be used when a user has lost

their card

2 User ID #

To delete a card user by Card number

Users can be deleted continuously without

exiting from programming mode

2 Card number #

To set a card and PIN user in card and PIN mode ( 3 1 # )

To Add a card and PIN user

(The PIN is any 4~6 digits between

0000&999999 with the exception of 1234

which is reserved.)

Add the card as for a card user

Press * to exit from the programming mode

Then allocate the card a PIN as follows:

* Read card 1234 # PIN # PIN #

To change a PIN in card and PIN mode

(Method 1)

Note that this is done outside programming

mode so the user can undertake this

themselves

* Read Card Old PIN # New PIN #

New PIN #

To change a PIN in card and PIN mode

(Method 2)

Note that this is done outside programming

mode so the user can undertake this

themselves

* ID number # Old PIN # New PIN #

New PIN #

To delete a Card and PIN user just delete

the card

2 User ID #

To set a card user in card mode ( 3 2 # )

To add and delete a card user The operating is the same as adding and deleting a card

user in 3 0 #

To delete All users

Note that this is a dangerous option so use

with care

2 0000 #

To unlock the door

For a PIN user

Enter the PIN then press #