User Manual

8
For a card User
Read card
For a card and PIN user
Read card then enter PIN #
1.2 Master Cards Using
Using Master Card to add and delete card users
Add a User Card
1. (Read Master Add Card)
2. (Read User Card)
Repeat Step 2 for additional user cards
3. (Read Master Add Card)
Delete a User Card
1. (Read Master Delete Card)
2. (Read User Card)
Repeat Step 2 for additional user cards
3. (Read Master Delete Card)
1.3 Relay Setting (Pulse mode, Toggle mode)
Pulse mode
(
factory default
)
Pulse mode - door relay time setting
4 1~99 #
The door relay time is between 1~99 seconds, the
factory default setting is 5 seconds.
Toggle mode (Latch mode)
Toggle mode
4 0 #
1.4 Door Detecting, Alarm, Sound and Light Settings
Door Open Detection
Door Open Too Long (DOTL) warning . When used with an optional magnetic contact or built-in
magnetic contact of the lock, if the door is opened normally, but not closed after 1 minute, the
inside buzzer will beep automatically to remind people to close the door and continue for 1 minute
before switching off automatically.
Door Forced Open warning. When used with an optional magnetic contact or built-in magnetic
contact of the lock, if the door is opened by force, or if the door is opened after 20 seconds of
the electro-mechanical lock not closed properly, the inside buzzer and alarm output will both
operate. The Alarm Output time is adjustable between 0~3 minutes with the default being 1
minute.
To disable door open detection
(Factory default)
6 0 #
To enable door open detection
6 1 #
Keypad Lockout & Alarm Output options. If there are 10 invalid cards or 10 incorrect PIN
numbers in a 10 minute period either the keypad will lockout for 10 minutes or the alarm will
operate for 10 minutes, depending on the option selected below.
Normal status: No keypad
7 0 # (factory default)