Owner manual

2.4.2 Performing a
Glass Mounted
Installation
Figure 2-4 shows the four IEI-supplied pressure-sen-
sitive adhesive pads and the two side cut-outs used
for this installation. In this configuration, the prox.pad
plus unit is affixed with the four self-adhesive pads to
the glass or the glass window adjacent to the controlled
door being accessed, on the interior side of the glass.
Oneofthetwosidecut-outsisusedtobringthewires
out of the side of the prox.pad plus case.
A typical glass mounted installation proceeds as fol-
lows:
1. Disconnect the back housing from the front key-
pad/controller. Remove the tape from the four
self-adhesive pads on the back housing and apply
the pads to the four corners of the backplate.
2. Affix the back housing to the glass d oor or the
glass window adjacent to the controlled door be-
ing accessed, on the interior side of the glass.
3. Determine which of the two side cut-outs on the
back housing to use for the wiring and “cut out”
that cut-out using the appropriate cutting tool.
4. Pull the wiring through the selected side cut-out
as required.
5. Connect the front keypad/controller to the back
housing.
6. Install the tamper screw into the hole at the bottom
front of the enclosure using a #6 spanner bit (not
included, but available from IEI).
2.4 M ounting the prox.pad plus Unit Chapter 2: Installation
prox.pad plus Install/Program. Manual, PPP, D4b 2-9
Part No. 6105679, Rev. 1.1