Owner manual

15
2 - 3500ETL-1K/3600ETL-1K OPERATOR INSTALLATION (Continued)
2.6 - Learning and Limit switch adjustment (Continued)
8. Press “OK” to allow the control board to scan for attached items, such as sensors, photo-
eye’s and other safety devices.
9. The gate will open partially then stop. This is being done, so the control board can sense the
type and operational condition of the drive motor. The gate will then run to the closed limit
switch so the board can properly sense the intended closed position.
10. The control board will then OPEN the gate slowly to establish travel and intended open posi-
tion by sensing the open limit switch.
11. Once the gate reaches the OPEN limit switch, the control board will now increase gate travel
speed to the highest speed allotted, and will now travel to the CLOSED limit switch at full
speed.
12. The gate opener is now programmed for basic usage.
The close tension on the gate can be further
adjusted by: Removing the 1/2” bolt on the
secondary arm (course adjustment 1”-2”).
Slide the adjustable arm out and rotate
counter clockwise to increase close pres-
sure and clockwise to reduce close pres-
sure. The three holes in the adjustable arm
will allow further adjustment if necessary.
Figure 20: Fine adjustment of gate close tension
Motor Disconnect Switch:
Flip the Motor Disconnect Switch to OFF to
disengage, flip the Motor Disconnect Switch to
ON to re-engage
Figure 19: Motor disconnect switch
2.7 - Motor Disconnect Switch
2.8 - Fine Close Limit Adjustment
ON
OFF