Owner's manual

ManualsBrandsControlled Products Systems Group ManualsSensorsMX000041

Installation Instructions

MX000041

HY-5A Vehicle Detector



Test the Vehicle Loop

Diagram 1.

HY-5A Vehicle Detector—front view

Diagram 2.

HY-5A Vehicle Detector—rear view

Standos

Vehicle loop sensivity levels explained on the

front label.

Screw terminals for loop wire

Vehicle loop sensivity dial

Metal pins t into

a socket on the

controller board.

Summary of content (6 pages)

PAGE 1
Installation Instructions MX000041 HY-5A Vehicle Detector Standoffs  Vehicle loop sensitivity levels explained on the front label.  Screw terminals for loop wire   Vehicle loop sensitivity dial Test the Vehicle Loop Metal pins fit into a socket on the controller board. Diagram 1. HY-5A Vehicle Detector—front view Diagram 2. HY-5A Vehicle Detector—rear view www.hysecurity.com Page 1 of 5 P/N MX000041 © 2013 D0306 Rev.
PAGE 2
Use Current Version of Software Table 1: Vehicle Loop Labels Smart Touch Controller Smart DC Controller Description Free Exit Exit Loop Inside Obstruction Inside Obstruction Outside Obstruction Outside Obstruction Connects to the outside reversing loop Shadow/Reset Center Loop Prevents a gate from starting open or closed when a vehicle is in the path of the gate. Shadow loops apply to swing gates. Reset loops are found on arm gates. Opens a fully-closed gate.
PAGE 3
CAUTION: Do NOT flex or wiggle the HY-5A detector as damage may occur to the Controller socket or the detector’s pins.  Finalize Loop Installation Screw terminals for loop wire Diagram 5. Correct orientation and installation of the HY-5A detector Sensitivity dial Indicator light   HY-5A HY-5A  Combining Loops or Detectors Power switch Diagram 6. HY-5A detectors installed www.hysecurity.com Page 3 of 5 P/N MX000041 © 2013 D0306 Rev.
PAGE 4
Sensitivity dial Adjusting HY-5A Sensitivity Smart Touch Controller display and navigational buttons Smart DC Controller display and navigational buttons Configuring Software Diagram 7. Sensitivity dial     Diagram 8. Keypads www.hysecurity.com Page 4 of 5 P/N MX000041 © 2013 D0306 Rev.
PAGE 5
Troubleshooting     Table 2. Troubleshooting Tips Symptoms Problem Resolution Intermittent detection. False vehicle loop detection where gate seems to be detecting ghost images or signal is not reaching HY-5A detector. HY-5A detector is not seated properly into the Controller board. Symptoms can also occur when the HY-5A detector is seated improperly during installation. Do NOT flex the module into place. See Diagram 9. Refer to Diagram 5 for the correct orientation.
PAGE 6