CARROT 3 - CHILD RESTRAINT SYSTEM For Children with Special Needs Instruction Manual ! WARNING! Read all instructions before using this restraint system.
CARROT 3 CHILD RESTRAINT SYSTEM The Carrot 3 is designed to provide additional support for children who have difficulty sitting correctly in conventional car seats. Always consult your doctor to make sure that this restraint system is suitable for your child. Your child’s safety is very important to us. To ensure that your restraint system is installed correctly, please read all the instructions in this manual before use. If you require additional assistance, please call Convaid at (888) 266-8243.
Table of Contents CHEST SUPPORT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 Chest Support Pad Adjustment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 Harness Buckle - Fastening / Releasing . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 LATERAL SUPPORT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15 Lateral Support Adjustment . . . . . . . . . . . . . . . . . . . . . .
! WARNING ! DEATH or SERIOUS INJURY can occur • Failure to follow all instructions and product labels can result in death or serious injury in a crash. Carefully read and understand all instructions on this child restraint and in the written instructions. If you have questions, contact Convaid at 1-888-CONVAID (266-8243). • Use only with children who weigh between 30 and 108 pounds (mass between 13.6 and 49 kg) and whose height is between 37 and 60 inches (94 and 152 cm).
! WARNING ! DEATH or SERIOUS INJURY can occur • Discontinue use of your child restraint if it has been involved in ANY type of accident. It may no longer be effective and should be replaced immediately. • This child seat must not be used in the home, in boats, or other non-certified applications. • Always keep this child restraint secured in the vehicle, even when not in use. In an accident, an unsecured child restraint system may injure other occupants.
Safety Information · This child restraint system conforms to U.S. Federal Motor Vehicle Safety Standard FMVSS 213. · This restraint is certified for use in motor vehicles and aircrafts. · Register this restraint with the manufacturer. Child restraints could be recalled for safety reasons. To be reached directly in the event of a recall, you must register your restraint with the manufacturer.
Safety Information ! WARNING! It is your RESPONSIBILITY to use the Vehicle’s Safety Belts at the same time. DO NOT secure a child only with the harness straps (5-point) of the child restraint; ALWAYS use the vehicle’s lap shoulder (3-point) safety belt at the same time to secure the child restraint and the child. Not using vehicle’s lap shoulder (3-point) safety belt could cause your child restraint to not perform as intended, and increase the potential of Serious Injury or Death. Figure A.
Safety Information ! WARNING! This child restraint must be used in a forward-facing position only. ! WARNING! Before reclining the back, you must release and loosen the harness straps. Once reclined, re-tighten the harness straps. Reclining the back without loosening the harness straps may cause choking. The Carrot 3 was tested at a 30º recline from vertical, and should not be transported in a moving vehicle past this point.
Features: Carrot 3 Standard Model Top Tether Strap (Optional Accessory) Head Pillow Head Support Shoulder Strap Comfort Pads Vehicle’s Belt Path Body Balance Pads Seat Backrest Chest Pad Support Harness Adjuster Chest Pad Support Height Adjuster Harness Yoke Harness Buckle LATCH Connector with 4” extensions with 2” extensions Measurements shown are with the extensions added. * Extensions not included with standard model. Backrest Height 11.8” 12.8” 13.8” 14.8” 15.8” 16.8” Seat Depth 9.
Features: Carrot 3 Standard Model Top Tether Strap (Optional Accessory) Shoulder Width Adjustment Button Shoulder Protector Wings (Optional Accessory) Sholuder Harness Backrest Instruction Guide (inside) Hip Pads Lap Belt Guide Storage Pocket Comfort Seat Cushion Seat Depth Adjustment Knob Measurements shown are with the extensions added. * Extensions not included with standard model.
Installation Lower Anchor and Tethers for CHildren LATCH Installation This child restraint system is recommended for use in a vehicle with LATCH anchors. Verify that your vehicle is equipped with LATCH anchors. Lower Anchor Straps Installation: 1. Press and hold the first LATCH adjuster release button, then pull the LATCH strap to full length. Repeat for the remaining LATCH connector (Fig. A). 2. Place the child restraint forward-facing on the vehicle seat. Fig. A 3.
Installation USING LATCH Top Tether Strap If your vehicle is equipped with LATCH Top Tether Anchor points, you can use the Top Tether Strap to attach the Head Support. NOTE: All vehicles manufactured since September 1, 2002 are equipped with tether anchors located behind the rear seats. 1. Consult your vehicle owner’s manual to locate the tether anchor points. 2. Pull and fully extend the top tether strap (Fig. A or B). 3. Locate the hook on the strap and loosely attach the tether strap to the anchor point.
Functions Head Support Head Support Depth Adjustment The Head Support can be adjusted forward or backward by 0.6” (1.5 cm) increments to provide a better fit and added protection for the occupant (Fig. A). To Adjust: Remove screws on each side of the head support with a Phillips screwdriver. Move the head support to selected position, and reinsert screws (Figs. B & C). 3 2 1 Fig. A Fig. B Fig.
Functions Shoulder Support Harness Strap Adjustment Harness Strap Harness Adjustment Strap (A) Shoulder Harness Strap (B) The Harness Strap comfortably positions the child in place. To tighten the shoulder harness strap, pull on the harness adjustment strap (Fig. A). To loosen the harness strap, press and hold the harness release lever (Red), while pulling the shoulder harness strap (Fig. B). NOTE: Do not pull on the padded covers or chest support pad when loosening the harness strap.
Functions Shoulder Strap Comfort Pad The shoulder strap comfort pad can be moved by readjusting the Velcro attached to the back of the Head Support. Shoulder Protector Wing (OPTIONAL ACCESSORY) The Shoulder Wing has up to 4” of width adjustment. To adjust the width, press/ hold the yellow button on the back of the shoulder wing, and pull the shoulder wing outward to the desired position. (Fig. A).
Functions Shoulder Protector Wing Installation 1. Detach straps from shoulder strap harness bracket. Remove straps and padded covers from chair (Fig. A & B). 2. Press and hold height adjustment buttons, and remove head support (Fig. C & D). 3. Remove 2 screws located on the rods (Fig. E) 4. Insert head support rods into the shoulder wing rods, and press together (Fig. F). 5. Align the holes located on the rods, insert 2 screws and tighten. (Fig. G). 7.
Functions Chest Support ! WARNING! The top of the Chest Support Pad must be at armpit level or lower. Positioning the support pad too high may cause choking Chest Support Pad Adjustment To raise the height of the Chest Support Pad, press & hold the Height Adjustment Lever (Yellow) on the front of the child seat, and pull on the pad (Fig. A). To lower the chest support pad, pull the chest support strap (Fig. B). Press & Hold Yellow lever Fig. A Fig.
Functions Lateral Support Lateral Support Adjustment (OPTIONAL ACCESSORY) Lateral supports are used to maintain midline positioning of the trunk. To adjust: 1. Unfasten the Velcro and the zipper on the back upholstery. 2. Pull back the upholstery. (Fig. A) 3. Loosen 2 screws with a 7/64” Allen Wrench. (Fig. B) 4. Slide lateral to desired height and width. (Fig. C) 5. Retighten the screws. (Fig. D) 6. Repeat steps 2 - 5 on opposite side. 7. Secure the upholstery. 15 Fig. A Fig. B (Fig. C) Fig.
Functions Backrest IMPORTANT: · Height of the shoulder harness strap moves with the height of the backrest. · The Shoulder Harness Strap must be at or above the child’s shoulders, and parallel to the ground. · The Shoulder Harness Strap is for positioning only, and not designed to support occupant in a crash. Backrest Height Adjustment The height of the backrest can be adjusted as the child grows. To adjust: Pull and hold the black “D” shaped ring at the top of the backrest to release lock.
Functions Seat When the child is sitting with knees bent, the total seat length should be slightly shorter than the length from the pelvis, to the rear of the knee. Seat Length Adjustment – 2” or 4” Release lock by pulling the black “D” shaped ring - Seat Depth Release Strap on the front of the child restraint, and while pulling the strap, adjust the position of the rodded seat extension.
Functions Rodded Seat Extensions (OPTIONAL ACCESSORY) Rodded Seat Extension - Long Allows the legs to be stretched out and comfortably supported. Rodded Seat Extension - Short (OPTIONAL ACCESSORY) Allows the knees to be bent, with the femurs comfortably supported. Pommel (OPTIONAL ACCESSORY) The Pommel separates thighs to improve hip alignment and stabilize sitting posture.
Functions Seat Depth Adjustment The seat depth can be adjusted a maximum of 1.4” (3.5 cm) by moving the location of the Seat Depth Adjustment Knob. To change the seat depth; remove the adjustment knob, reposition to the desired location and reattach. Note: The knob MUST go through the plastic cover, the seat back rod and the seat rod. Footrest (OPTIONAL ACCESSORY) Footrests are available in three sizes - short, medium and long.
Functions Pads and Cushions (STANDARD ACCESSORIES) The following Pads and Cushions are provided as standard accessories, and easily attach / adjust with Velcro. Head Pillow Provides comfort and lateral head support. Body Balance Pads Used to balance / position the user. Hip Pads Provides proper positioning for balance, comfort and support. Comfort Seat Cushion Provides additional comfort and prevents the child’s pelvis from slipping forward.
Securing Your Child Securing Your Child Once the child restraint has been installed in the vehicle and adjustments have been made, follow these instructions to secure the child. 1. Loosen the harness by pressing the harness strap release lever (Red) on the front of the child restraint, and pull the shoulder straps forward (Fig. A). 2. Unfasten the harness buckle by pressing the release button and sliding the tongues out (Fig. B). Fig. A Fig. B 3.
Securing Your Child ! WARNING! It is your RESPONSIBILITY to use the Vehicle’s Safety Belts at the same time. DO NOT secure a child only with the harness straps (5-point) of the child restraint; ALWAYS use the vehicle’s lap shoulder (3-point) safety belt at the same time to secure the child restraint and the child. Not using vehicle’s lap shoulder (3-point) safety belt could cause your child restraint to not perform as intended, and increase the potential of Serious Injury or Death. Figure A.
Care and Maintenance Upholstery Cover, Cushions, Pillows and Pads Upholstery Cover: SPONGE CLEAN using cold water & mild soap, and TOWEL DRY. Do not remove the upholstery cover. Contact the distributor for removal or replacement of the upholstery. Cushions, Pillow, and Pads: HAND WASH using cold water and mild soap. LINE DRY or LIE FLAT to prevent shrinkage. Do not bleach, machine wash, machine dry or iron, as this may damage fabrics. When damage to fabric occurs, it must be replaced.
Warranty For your convenience, record all the information about your child restraint below.
Warranty LIMITED FIVE-YEAR WARRANTY This product is warranted against defective materials and workmanship for five years from the date of original purchase. Proof of purchase is required. To make a claim under this warranty, contact the authorized distributor or the retailer from whom you purchased this product. Proof of purchase is required. WARRANTY LIMITATIONS This warranty does not include damages which arise from negligence, minor use not in accordance with the product instruction.
