Instruction manual
Installation
USING LATCH Top Tether Strap
If your vehicle is equipped with LATCH Top Tether Anchor points,
you can use the Top Tether Strap to attach the Head Support.
NOTE:
All vehicles manufactured since September 1, 2002 are
equipped with tether anchors located behind the rear seats.
1. Consult your vehicle owner’s manual to locate the
tether anchor points.
2. Pull and fully extend the top tether strap (Fig. A or B).
3. Locate the hook on the strap and loosely attach the
tether strap to the anchor point.
4. Pull the tether strap to remove ALL slack (Fig. B).
5. Make sure the tether strap is taut and that child seat
is properly secured.
NOTE:
The child restraint is secure when it cannot be moved
front-to-back or side-to-side more than 1 inch (2.5 cm) at
the belt path. If the child restraint is not secure, repeat the
installation process or use an alternate seating location.
Aircraft Installation
This restraint is certied for use in an aircraft. Most airlines allow
the use of a child restraint if it has been approved for airline use
and properly ts into the aircraft. Contact your airline about their
child restraint policy before traveling.
· The FAA recommends that a child weighing up to 40 lbs
(18.1 kg) use a certied harness child seat while traveling
on an aircraft.
· Install child restraint in a window seat.
· If the aircraft lap belt is too short, ask the ight attendant
for a belt extender.
Fig. A (Car)
Fig. B (Van)
9