Instruction manual

Securing Your Child

Once the child restraint has been installed in the vehicle and

adjustments have been made, follow these instructions to secure

the child.

1. Loosen the harness by pressing the harness strap release lever

(Red) on the front of the child restraint, and pull the shoulder

straps forward (Fig. A).

2. Unfasten the harness buckle by pressing the release button and

sliding the tongues out (Fig. B).

3. Move each harness strap to the side of the child seat (Fig. C).

4. Place the child in the child restraint (Fig. D).

5. Position the harness straps around the child and fasten the

harness buckle (See Backrest Section for harness adjustment).

Proper connection is conrmed when a positive click is heard

after inserting each buckle clasp (Fig. E).

6. Slowly pull the harness adjuster strap to tighten the harness

around the child (Fig. F).

7. Verify that harness is not twisted and child is properly secured.

8. Fasten vehicle’s lap shoulder belt over the child restraint by

routing the belt through the upper RED belt guides on the child

restraint (Fig. G).

9. Make sure that the vehicle’s lap shoulder belt is not twisted or

loose, and the child is properly secured.

IMPORTANT:

・ Always park your car in a safe place to make any adjustments to

the child restraint system. Adjusting and/or handling the child

restraint when driving could cause DEATH or SERIOUS INJURY.

・ Always pull on the harness after securing the child, to ensure

the buckle clasps are secure in the harness buckle.

・ When driving, the child restraint must be in the most upright

position, unless medically necessary.

Fig. A

Fig. B

Fig. C

Fig. D

Fig. E

Fig. F

Fig. G