User`s guide

WHEELS
26
Install outer pad by dropping the spring
side over the small post. Push upward
until the spring clips lightly onto the
post. Fig.90
NOTE: Spring should lightly clip onto
the small post in the center of
the piston and push inward.
Using the 2.5 mm Hex wrench inserted
into (A), replace the pad into the
housing. At the same time, turning
anti-clockwise, insert a flathead
screwdriver to push the pad. Fig.89
To install new pads, first insert inner pad
as shown
Fig.88.
Fig.88
Fig.89
Fig.90
A
Push Up