OWNER’S MANUAL Portable Evaporative Cooler ILL1409-A M3000 Coolmaster ® (English) (M3000)
CONTENTS SAFETY.........................................................................1 General Safety Electrical Safety COMPONENT LOCATION............................................2 ASSEMBLY................................................................... 3 OPERATING THE COOLER.........................................
SAFETY Portable evaporative air cooler important safety instructions Electrical Safety Please read these instructions before assembling the cooler and keep for future reference. Caution! before connecting the electrical power cord to a power outlet, check that the air cooler voltage is the same as your power supply (refer to the rating label located on the rear of the unit).
COMPONENT LOCATION Congratulations on purchasing your Convair cooler, manufactured and backed by Convair, a world leader in climate control. In one compact, lightweight, easy to use and attractive design, the Convair cooler keeps your office or home space clean and cool all year long. The Convair cooler is a powerful evaporative cooler, that will give you plenty of cool, fresh air. Place the cooler in front of an open door or window so that it is drawing in fresh air.
ASSEMBLY Unpacking the cooler Unpack the cooler onto a carpet or similar soft surface. The legs and wheels are located underneath the unit. Before assembling the trolley push the wheels onto plastic pins in the legs (Fig 2). ILL221-A 2 ILL222-A 3 ILL223-A 4 Assembly of trolley Press two of the legs into the corner recesses at one end of the cabinet so that the holes for the magazine rack face the other two recesses (Fig 3). Introduce the ends of the magazine rack into the holes.
OPERATING THE COOLER How to get the best cooling performance 6 Place the cooler with its back near to an open window or door so it can draw in 100% fresh air. Open another window or door on the opposite side of the room for 'flow through' ventilation (Fig 6). This cooler will not cool properly in a closed room. Filling with water Turn the cooler off before filling. The water inlet door is opened by pulling it at the top (Fig 7). Fill the appliance with clean water. The water capacity is 18 litres.
OPERATING THE COOLER cont. Using the cooler AIR When this appliance is used as an air cooler it should be filled with water and the 'COOL' knob turned to the 'ON' position (Fig 10). Low fan speed (1) is selected for quietest operation (Fig 11). 0 3 1 2 COOL On 10 ILL229-A High fan speed (3) is for maximum cooling (Fig 12). AIR Fan only (ventilation). The cooler may be used as a fan only. This is set by turning the 'COOL' knob to the 'OFF' position (Fig 13).
MAINTENANCE Cleaning The exterior surfaces can be wiped with a damp cloth and a little household detergent. Do not use abrasive cleaners and solvents (Fig 15). Unplug the cooler from the power supply before servicing. ILL232-B 15 14 At least once per year at the end of summer it is advisable to perform some simple cleaning on your cooler to maintain its high efficiency. This involves cleaning the water system and Aspen filter pad.
MAINTENANCE cont. Internal view (fig 17,18 & 19 ) L J K L N J Aspen cooling pad Wire mesh support Spreader Water Strainer K 17 14 15 ILL233-B Spreader pad removal 1 Remove the Aspen pad assembly (J, K & L) by lifting it upwards. Disconnect the water hose from the spreader (L) before removing the Aspen pad assembly completely. L K J 18 16 ILL234-A Cleaning inside of unit Wash the Aspen pad with water; replace if worn or deteriorated.
TROUBLESHOOTING CONDITION POSSIBLE CAUSE REMEDY 1.1 Power outlet or supply faulty. 1.1.1 Switch on power outlet. 1.1.2 Check power supply. 1.1.3 Check power outlet. 1.2 Wrong voltage. 1.2.1 Check that power supply is the same as specified on the rating label. 2. Cooler stops operating after running for some time. 2.1 Motor overheated (safety cutout). 2.1.1 Wait 30-45 minutes for motor to cool down and it will restart automatically. If condition persists take the cooler to a service agent. 3.
Tank & Baffles Rear Panel Side Panel Top Panel Grommet Motor Mounting Clip Motor Mounting Scroll Assembly Scroll Upper Scroll Lower Fan Wheel (centrifugal) Vane Link Assy (4 vanes, 2 links) Lever Vane Baffles Tank (Left & Right) Panel Front Filler Door/Name Badge Assembly Filler Door Name Badge Magazine Rack Leg & Pintle Assembly Pintle Castor Wheel Assembly Knob - Cool Knob - Fan Louvre Horizontal Set 1 2 3 5 6 7 8 8.1 8.2 9 10 11 12 13 14 14.1 14.2 15 16 17 18 19 20 21 22 26 27 28 29 30 32 33 34.1 34.
M3000 COOLMASTER EXPLODED VIEW As the policy of this company is one of continuous improvement, all specifications are subject to change without notice.
WARRANTY In this warranty: We or us means Seeley International Pty Ltd ABN 23 054 687 035, and our contact details are set out at the end of this warranty; You means you, the original end-user purchaser of the Goods; Supplier means the authorised distributor or retailer of the Goods that sold you the Goods in Australia; and Goods means the product, unit, appliance or equipment which was accompanied by this warranty and purchased in Australia.
WARRANTY cont. 4. We are not responsible in any way for any failure and/or inadequate performance of the Goods which arises from or is connected to the use in the Goods of non-genuine spare parts. We strongly recommend that only spare parts supplied or approved by us are used in the Goods. 5. No other person, firm or corporation is authorised by us to offer or give on our behalf any other or greater warranty than that given under this warranty.
WARRANTY cont. To ensure that service either pursuant to the above warranty or otherwise is readily available, we have established in all States authorised service centres, which are available to deal with service requirements. For further information about your nearest service centre and other enquiries please call our Service Centre on: 1300 650 644 Please retain your receipt as proof of purchase. Every request for warranty must be accompanied by proof of purchase.
It is the policy of Seeley International to introduce continual product improvement. Accordingly, specifications are subject to change without notice. Please consult with your dealer to confirm the specifications of the model selected. Warranty Service Australia 1-300-650-644 seeleyinternational.com ® 830018-C convair.net.