DIVA 7647 421AA2219 Installation & Operating Instructions ATTENTION : Documents to be kept by end-user
INTRODUCTION : Dear owner, - Congratulations on the purchase of this premium electric heater. CONVECTAIR develops and produces the highest quality heating product in the electrical industry. - To obtain the best results and the ultimate in performance and comfort, please take a moment to read the installation, operation and maintenance instructions detailed in this manual. TABLE OF CONTENTS QUICK START GUIDE................................................................................................
- QUICK START GUIDE Heating indicator On/Off indicator Comfort zone On/Off/Turbo switch Timer indicator Timer switch (1/2 hour, 1 hour, 2 hours) Thermostat adjustment Unheated ventilation switch ( “Summer mode”) Fig. 1 “Summer mode” indicator Electrical requirements : 240 V, 208 Install a standard 2'' x 3'' wall junction box, 30 cm (12 in.) from the floor, centered on the heater. Installing and connecting the heater See pages 5 and 6.
1 SPECIFICATIONS - Your new Diva combines both radiant and fan-forced heat. It is designed to heat the room as well as to dry towels, a perfect combination for the bathroom. - The Diva is composed of a silent radiant vertical panel of 700 watts, controlled by an electronic thermostat, to heat the room and dry towels. The fast-acting boost provides 1500 watts of combined radiant and fan-forced heat, with a timer control.
AND MOUNTING RECOMMANDATIONS DE MISE EN PLACE 3 1 INSTALLATION - Identify where you want to install the heater, providing sufficient clearance around the unit (Fig. 2). Fig. 2 C B B - Locate and unscrew the lower bracket. D - Unscrew the top bracket from the back of the heater. Fasten it to the wall in the position shown in the diagram below (mark A), making sure that it is level (Fig. 4).
CONNECTION RECOMMANDATIONS DE MISE EN PLACE 4 1 ELECTRICAL - CONVECTAIR recommends that your heater be installed by a qualified electrician and in accordance with national and local codes. - To prevent short circuits and electrical shocks turn the power off at the main panel before attempting the installation or making any repairs. - If the power cable is damaged it must be replaced by the manufacturer, an approved service depot or a technician with similar qualifications to avoid any danger.
INSTRUCTIONS RECOMMANDATIONS DE MISE EN PLACE 5 1 OPERATING The electronic controls have been designed to achieve maximum savings. Heating indicator On/Off indicator Comfort zone On/Off/Turbo switch Timer indicator Timer switch (1/2 hour, 1 hour, 2 hours) Thermostat adjustment Unheated ventilation switch ( “Summer mode”) Fig. 5 “Summer mode” indicator To turn the heater On : - Press briefly on the On/Off/Turbo switch. The On/Off indicator light turns on.
Using the timer When activating the timer, the Diva provides 1500 watts of power combining radiant and fan-forced heating, for short periods of time (during a bath or shower). - With the heater on, press the timer switch. Continue pressing on the timer switch to set the desired time or to turn the timer off in the following sequence : ½ hr, 1 hr, 2hr Off. Each timer indicator light shows the selected time.
16 OVERHEAT CONTROL DE MISE EN PLACE RECOMMANDATIONS - This heater is equipped with separate overheat controls for the radiant panel and for the fan-forced heat. In case of a malfunction of the unit (blocked air output or intake, for example) the heater will stop heating automatically. After correcting the malfunction the heater can be reset.
SHOOTING RECOMMANDATIONS DE MISE EN PLACE 8 1 TROUBLE Before calling your electrician, please go through these simple checks: 1- Make sure the breaker in the distribution panel is in the "ON" position. 2- Check that the On/Off switch is on . 3 -Turn the timer on. 4- If no heat is emitted, check the two overheat protections : first remove any obstruction from the inlet and outlet grilles ; then reset the overheat protections (see sect.6 , p.9).
