User's Manual

CSL CS208-3G INTELLIGENT INTEGRATED READER with GPS USER'S MANUAL, VERSION 1.0.0

8 Regulatory Information

8.1 Federal Communications Commission

Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there is

no guarantee that interference will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interference by

one of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.

Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party responsible

for compliance could void the user's authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. This equipment should be installed and operated with minimum distance 1m

between the radiator & your body.

This device and its antenna(s) must not be co-located or operating in conjunction with any

other antenna or transmitter. This product must be installed by a professional

technician/installer.

FCC Radiation Exposure Statement:

To comply with FCC RF exposure compliance requirements, the antennas used for this transmitter must be

installed to provide a separation distance of at least 1m from all persons and must not be co-located or operating

in conjunction with any other antenna or transmitter.