Owner`s manual

nanoFlash FAQs
10-Apr-10 ©Convergent Design, Inc. Page 30 of 42
nanoFlash can detect the presence of a valid HD/SD-SDI input. Therefore, it can be
programmed to switch from active state (6 Watts power) to standby state (0.2 Watts of
power) when the HD/SD-SDI signal is turned off (when you turn off your camera).
nanoFlash requires about 4 seconds to reboot when the HD/SD-SDI signal re-appears.
nanoFlash automatically powers down the SDI transmitter and the HDMI I/O if no cable
connection is detected. When the HDMI input is active, due to technical limitations, the
nanoFlash cannot detect when the HDMI signal goes away, thus the nanoFlash cannot
enter low power mode automatically.
130. What type of battery can be used with the optional battery adapter?
We also offer our own battery and charger for the nanoFlash. It offers a run time of
approximately 3.0 hours.
131. Can nanoFlash monitor the battery level?
nanoFlash does not have a battery gas gauge per se, but does display the incoming
voltage. So, by watching the voltage level, you can easily determine if the battery is
nearly discharged. In a future firmware update, the nanoFlash will automatically close
the last clip and power-down when the battery is near full discharge level.
132. What are the power cable options offered by Convergent Design?
We offer three power cable options:
a) 4-Pin Hirose to D-Tap
b) 4-Pin Hirose to XLR
c) 4-Pin Hirose to Flying Leads (for DIY users)
4-Pin Hirose to 2-Pin D-Tap Remote Start & Tally HD-SDI Cable
133. Does nanoFlash have an internal fan?
No, nanoFlash utilizes substantial internal heat sinks to dissipate the heat to the
aluminum case. Fans were deemed too noisy and a reliability issue.
134. What material is used for the cabinet?
The cabinet is all aluminum, since it is rugged, lightweight and has excellent heat
conduction characteristics.
135. Does nanoFlash include a battery or any power supply?
nanoFlash has a 4-pin Hirose power jack for battery power, or for DC power from the
110/220V AC power supply included with the nanoFlash. The nanoFlash does not