User`s manual

Pg4uwMC Settings dialog

Pg4uwMC Settings dialog is used to set or display following options:

Table containing information / settings for Programmer Sites

On the top of Pg4uwMC Control panel is table which contains three columns:

column Sites contains checkboxes with Site numbers #1, #2, #3, #4 used to

enable/disable using individual Programmer Site with specified Site number

column Serial number contains information about serial numbers for Programmer Sites

column Project file contains edit lines Project: #1, Project: #2, ...Project: #4 for setting

individual projects to be loaded after running each Pg4uw. Project file names can be

entered manually or by dialog Select project file, which can be opened for each Site by

clicking on button "..." placed on the right side of each project edit line. If the project name

edit line is blank, the automatic project load will not be performed.

Checkbox Use Site #1 project for all Sites

Checkbox Use Site #1 project for all Sites placed under the Sites numbers and Projects table.

When there is requirement to program the same device types with the same data, the

checkbox should be checked.

If the checkbox is checked, the project file for Site #1 will be used also for all other

Programmer Sites. In this mode all Sites are using the same shared buffer of project data

and program the same device type.

If the checkbox is not checked, each Site will use its own project file defined by name in

table of Sites in column Project file. In this mode each Site is using its own buffer of

project data, which allows to program different data to different types of devices at the

same time in each Site.

Checkbox Automatic YES!

Automatic YES! checkbox - when checked, Automatic YES! is set on for all programmers. For

more details about Automatic YES! feature see Programmer / Automatic YES. This feature

may not be available for some types of programmers.