User`s manual

848A elements

1) 32 pin ZIF socket

2) power LED

3) LPT connector for PC  848A communication cable

4) LED, which indicate work result

5) Power supply connector



Power supply connector



Connecting 848A programmer to PC

Switch off the PC and programmer. Insert the connection cable, included in the 848A

programmer delivery, to the free printer port of PC. If your computer is equipped with only one

printer port, substitute the programmer cable for the printer cable. Connect the opposite cable

end to the programmer. Screw on both connectors to counter connectors. This is very

important mainly for the connector to programmer. Though replacing the printer cable by the

programmer cable is uncomfortable, it is not recommended to operate the 848A programmer

through a mechanical printer switch. Use of an electronic printer switch isn't possible.

Connect the mains connector of the power supply (or wall-plug power supply self) to a mains

plug, connect the connector to the appropriate programmer's connector. Then, on the

programmer lights up LED POWER and the programmer 848A is ready to run. Next switch on

the PC and run the control program.

Caution! If you don't want to switch off your PC when connecting the 848A, proceed as

follows: