Troubleshooting Guide

Technical Specification
Product:
1350RF
Vibration level:
10G
Resolution:
1280*960 pixels (NTSC)
Min illumination:
0.1LUX
IR LED:
8 pcs
Night Vision distance:
16 ft
Waterproof rating:
IP68
Viewing Angle:
Vertical:71°
Horizontal:123°
Diagonal:150°
Power voltage:
9V ~ 36V
Operation temp:
-20℃~+70℃ / -40℃~+70℃ (with heating)
Antenna:
3DB
Connector:
DTM04-2P
Maintenance
Although this Rear View Camera requires little care, you can still maintain its condition and performance by
following these steps:
Occasionally clean the camera lens with damp soft cloth.
Should you experience any problem with the camera please refer to the troubleshooting guide below prior to
returning your camera for repair.
Note: The user should not attempt to service the unit beyond that described in the operating instructions. All
other servicing should be referred to qualified personnel.
Hardware Warranty
Subject to the provisions described below, our product is protected for One year against defects in material and
workmanship.
Should a product fail to perform as described above within the warranted period, it will be repaired or
replaced with the same or functionally equivalent product by us.
This warranty does not apply if , in the judgement of us, the product fails due to damage from shipment,
handling, storage, accident, abuse or misuse, or if it has been used or maintained in a manner not conforming
to product manual instructions, has been modified in any way. Repair by anyone other than us or an approved
agent will void this warranty. The maximum liability of our company under this warranty is limited to the
purchase price of the product covered by the warranty
FCC Statement
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
ＲＦ Ｅｘｐｏｓｕｒｅ Ｗ ａｒｎｉｎｇ Ｓｔａｔｅｍｅｎｔｓ：
Ｔｈｉｓ ｅｑｕｉｐｍｅｎｔ ｃｏｍｐｌｉｅｓ ｗｉｔｈ ＦＣＣ ｒａｄｉａｔｉｏｎ ｅｘｐｏｓｕｒｅ ｌｉｍｉｔｓ ｓｅｔ ｆｏｒｔｈ ｆｏｒ
ａｎ ｕｎｃｏｎｔｒｏｌｌｅｄ ｅｎｖｉｒｏｎｍｅｎｔ． Ｔｈｉｓ ｅｑｕｉｐｍｅｎｔ ｓｈａｌｌ ｂｅ ｉｎｓｔａｌｌｅｄ ａｎｄ ｏｐｅｒａｔｅｄ ｗｉｔｈ
ｍｉｎｉｍｕｍ ｄｉｓｔａｎｃｅ ２０ｃｍ ｂｅｔｗｅｅｎ ｔｈｅ ｒａｄｉａｔｏｒ ＆ ｂｏｄｙ．