User Manual

Copyright 2012 Page 3
4.9
Start-Up Sequence
4.9.1
Controlling Channel and Start-Up Baud Rate
4.9.2
Bluetooth Operation – S4I Lenses Only
4.9.3
Basic Lens Response Types
5. CORE Command Set
5.1
CORE Commands for All Lens Types
5.1.1
Command N - Retrieve Fixed Data: Required first Command
5.1.2
Command D - Retrieve one set of ASCII Calculated Data
5.1.3
Command Kd - Retrieve one set of Packed Binary Calculated Data
5.1.4
Command K3 - Retrieve name of Lens Manufacturer
5.1.5
Command K4 - Retrieve name of Lens Type
5.1.6
Command P - Retrieve board Temperature
5.1.7
Command B - Retrieve board Firmware Version
5.1.8
Command Kbn - Set Baud Rate
5.1.9
Command C - Set "Continuous Send" mode & Transmit ASCII Calculated Data
5.1.10
Command Kc - Set "Continuous Send" mode & Transmit Packed Binary Data
5.1.11
Command G - Set "Checksum" mode
5.1.12
Command Ka - Set "Inhibit Error Response" mode
5.1.13
Command X - Set Display Units to Imperial
5.1.14
Command Y - Set Display Units to Metric
5.1.15
Command V - Set "Film Size" to 35mm (default value)
5.1.16
Command W - Set "Film Size" to 16mm
5.1.17
Command Wnn -Set Film Size / Circle of Confusion Value
5.1.18
Command H - Stop "Continuous Send"; clear "Checksum"; clear "Inhibit Error”
5.2
CORE Commands for 5I ILLUMINATION COMMANDS
5.2.1
Command Kjn - Set "Scale Illumination" for both LED sets
5.2.2
Command Kkn - Set "Scale Illumination" for one LED set
5.3
5I START-UP UNITS COMMANDS
5.3.1
Command OX - Set Start-Up Units to Imperial
5.3.2
Command OY - Set Start-Up Units to Metric
5.4
CORE Commands for 5I SETTINGS & EXTERNAL INTERFACE [EDSU]
5.4.1
Command OS - Retrieve Channel Settings for This Channel
5.4.2
Command OT - Retrieve Baud Rate, Data Type, Display Unit [Opposite Channel]
5.4.3
Command OC - Commence Append of Data String
5.4.4
Command OD - Append Data String (up to 60 8-bit data values)
5.4.5
Command OH - Halt Append of Data String
6. Measurement and Calculation Units
6.1
Measured Values and Calculated Values
6.2
Start-Up Units