Operator`s manual

14
Fast Eddy’s™ by Cookshack FEC120 Operator’s Manual, V. 14
Switch on pellet hopper is
not in contact with the lid
Dirty fire pot
Trouble with igniter
Not enough intake air
Temperature is over 130°F
pellet dust out, then fill
with pellets
Clear pellets so the lid
will fully close or adjust
the switch to make
contact with closed
hopper lid
Open firebox and clean
fire pot and try to restart
unit
Open pellet hopper lid
and push the start button
Open the firebox and
feel over the pot. If the
pot is hot, the igniter is
fine. If pot is cold,
contact Customer
Service.
You can manually light
the unit also-see
procedure in startup
section
Check air intake fan-if
not turning, contact
Customer Service
If fan is turning, refer to
the installation
instructions and verify
that the vent pipe is
properly installed
Light manually or wait
for oven to cool