Operator`s manual

Fast Eddy’s™ by Cookshack FEC120 Operator’s Manual, V. 14

ALWAYS CLEAN THE FIRE POT BEFORE RESTARTING THE

OVEN.

 Recommended cooking times and temperatures are based on full loads

with no holding cycle. Larger or smaller loads or the addition of holding

time may require adjustment of cooking time and temperature.

 When you think the product is finished, turn the Master Switch to the

OFF position. Wait ten minutes before opening the oven door to check

the product for doneness.

 When the product is done to your satisfaction, remove from the smoker.

 An audible signal indicates that the cook cycle is complete and that the

oven is going to the Hold Temperature Mode.

 In order to see the set cooking temperature, probe temperature or holding

temperature, briefly press the corresponding button.

Cook Mode

COOK MODE is for standard operation and is the default mode. In COOK

MODE the oven will cook at the set cooking temperature for the set cooking

time. At that point, the controller will change to the set holding temperature and

remain there until the unit is manually shut down.

1. Turn Master Switch on the oven control panel to the ON position.

2. Set cooking temperature by pressing and holding the COOK TEMP button

while using the ADJUST TIME OR TEMP buttons to change settings.

3. Set holding temperature by pressing and holding the HOLD TEMP button

while using the ADJUST TIME OR TEMP buttons to change settings.

4. Set cooking time by pressing and holding the COOK TIME button while using

the ADJUST TIME OR TEMP buttons to change settings.

5. Press START.

PLEASE NOTE: The oven temperature displayed while the oven is

running is the actual air temperature inside the oven.

Probe Mode

PROBE MODE is used when cooking with the optional meat probe. In PROBE

MODE the oven will cook at the set cooking temperature until the internal

temperature of the meat reaches the temperature at which the probe is set. At that

point, the controller will change to the set holding temperature and remain there

until the unit is manually shut down.