Owner’s Manual for the cooktek sinaqua ™ souper ™ models: sas081-7, sas082-7, sas081-11 & sas082-11, sasd081-7, sasd082-7, sasd081-11 & sasd082-11 CAUTION: Read the instructions before using the equipment.
Original Instructions The information contained in this manual is important for the proper installation, use, maintenance, and repair of this equipment. Follow these procedures and instructions to help ensure satisfactory results and trouble-free service. Errors – descriptive, typographic, or pictorial – are subject to correction. Specifications are subject to change without notice. Please carefully read this manual and retain it for future reference.
Table of Contents Safety Instructions Important Safety Instructions General Safety Information Grounding Instructions Power Cord Replacement i i ii ii Specifications and Installation Theory of Operation Dimensions: Countertop Dimensions: Drop-In Certifications Electrical Specifications Installation: Countertop Installation: Drop-in 1 1 2 3 3 3 4-5 Use and Care Operation Maintenance 6 7 Troubleshooting 7 North America Limited Warranty 8
i IMPORTANT SAFETY INSTRUCTIONS WARNING: When operating this equipment, strictly adhere to the following safety precautions to reduce the risk of burns, electric shock, fire, injury, damage to equipment or property near equipment. GENERAL SAFETY INFORMATION • • • • • • • • • • • • • • • • • • • SAVE THESE INSTRUCTIONS safety instructions • • Read all instructions before using this equipment. This equipment must be grounded. Connect only to a properly grounded outlet.
ii safety instructions GROUNDING INSTRUCTIONS The SinAqua™ Souper™ must be properly grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing a safe path for the electric current. For your safety, never cut, remove, or disable the electrical (ground) connection from the plug. Never use an adapter plug or an extension cord with the SinAqua™ Souper™. WARNING: Electric shock can result from an improperly grounded plug.
1 1.37” (35 mm) 1.37” (35 mm) 2.29” (58 mm) 2.29” (58 mm) 14.86” (377 mm) 14.86” (377 mm) 10.36” (263 mm) 3.30” (84 mm) 11.20” (284 mm) 10.36” (263 mm) 3.30” (84 mm) 11.20” (284 mm) 4.75” (114 mm) 4.75” (114 mm) 13.70” (348 mm) 11.75” (298 mm) Figure 1: SinAqua™ Souper™ 7 qt. Dimensions Front View Figure 2: SinAqua™ Souper™ 11 qt.
C 2 SPECIFICATIONS AND INSTALLATION B 2.3” (58 mm) 14.9” (378 mm) 10.4” (264 mm) 2.3” (58 mm) 14.9” 11.1” (378 mm) (282 mm) 10.4” (264 mm) UNLESS OTHERWISE SPECIFIED: A 11.74” (298 mm) DIMENSIONS ARE IN INCHES TOLERANCES: 13.72” ANGULAR: MACH (348 mm) BEND .5 DEG Figure 3: SinAqua™ Souper™ 7 qt. Drop-In Dimensions Front View 8 7 Exterior - Souper™ 7 qt. 6 Height: 14.9” (378 mm) Diameter: 13.42” (341 mm) Cutout Diameter: 12” (305 mm) Weight: 11.92 lb. (5.41 kg) Packaged Weight: 13.45 lb.
3 Certifications 7 or 11 Qt Souper™ Models: SAS081-7, SAS081-11, SAS082-7, SAS082-11 SASD081-7, SASD081-11, SASD082-7, SASD082-11 UNITED STATES/ CANADA (208V) Electrical Specifications The SinAqua™ Souper™ must be plugged into a grounded, single-phase receptacle. See the adjacent data and check the rating plate on the unit to verify correct voltage and wattage. Incoming voltages that are below the product specification can result in less-than-rated power and slower heating times.
4 SPECIFICATIONS AND INSTALLATION Installation: Drop-in Installing the Souper™ and Control Box Install or locate this equipment only in accordance with the instructions below. 1. Connect the Micro USB cable to the Souper unit (Figure 5, below). 2. Install the Souper™ using the following surface cutout dimensions: - 7 Qt Souper™: 12-inch (305 mm) diameter hole - 11 Qt. Souper™: 14-inch (356 mm) diameter hole 3. Install the stainless steel overlay, if the accessory was ordered (Figure 6, below). 4.
5 Connect Micro USB cable here 4X .22” ø (5.59 mm) Back side of surface Figure 7: Control Box Installation .27” (6.86 mm) 4X .22” ø (5.59 mm) .43” (10.92 mm) 4.00” (101.6 mm) 4.86” (123.44 mm) 3.36” 3.90” (85.34 mm) (99.06 mm) .43” (10.92 mm) 4.00” (101.6 mm) 4.86” (123.44 mm) Figure 8: Control Box Cutout Dimensions .43” (10.92 mm) SPECIFICATIONS AND INSTALLATION .27” (6.
6 USE AND CARE Operation To edit the reheat temperature: a. While in Reheat mode, touch the Reheat icon. b. Use the arrows (4) to change the temperature. 1 4 5 2 3 6 7 8 9 NOTE: Adjust the temperature in increments of 5°F (2-3°C) from 140-200°F (60-93°C). c. Press the Checkmark icon (5) to store the change. NOTE: The Reheat icon will default to the last temperature set on the unit. Figure 9: Controller NOTE: The Stir timer (9) will default to ON when the Reheat icon is touched. 1.
7 Maintenance Follow the steps below when cleaning your SinAqua™ Souper™. Failure to adhere to these procedures may damage components, resulting in a non-warranty service call. DO NOT pour water into the chamber that is intended for the tureen. Water will drain (see Figure 5, page 4). DO NOT use steel wool or abrasive cleaners. Step 1: Turn the Unit Off and Allow it to Cool • Turn off the unit by touching the power button. • If there is food in the tureen, remove and store it as required.
8 NORTH AMERICA LIMITED WARRANTY North America Limited Warranty Two (2) Year North America Limited Warranty for “Portable” CookTek Products CookTek Product Models Covered Under this Limited Warranty “Portable” CookTek products shall mean all Single and Double Burner Cooktops (countertop or built-in), Woks (countertop or built-in), FaHeaters, Soup Warmers (countertop or built-in), ThermaCube Delivery Systems, and Pizza Delivery Systems.
9 Advance Replacement Warranty Service, Exclusive Remedy CookTek will be solely responsible for determining whether or not the Equipment or any component thereof is Defective. Defective Equipment will be repaired exclusively under CookTek’s Advance Replacement Warranty Service. Upon notification of a repair issue, CookTek will send an Advance Replacement Unit to the address provided at its expense. The Advance Replacement unit may be new or refurbished at CookTek’s sole discretion.
For service or information: wi thi n no r th a me r ica ca l l Customer Support at 800.90 T U R B O outsi de no r th a me r ica ca l l +1 214.379.6000 or Your Authorized Distributor Part Number: 105289 / Revision B / November 2018 Country Code: NA/EU Global Operations Customer Support 2801 Tr ade Center Dr ive Carrollton, Texas 75007 usa +1 214.379.6000 phone +1 214.379.6073 fa x 800.90 T U R B O +1 214.379.6000 www.cooktek.