Owner's Manual

15 4
Plug the IHW into a grounded, single-phase receptacle. Models IHW061-22 and
IHW061-24 will run on 100-120VAC drawing up to a maximum 650W. Models
IHW062-22 and IHW062-24 will run on 200-240VAC drawing a maximum of 650W.
Check the rating plate on the unit to verify correct voltage and wattage. Voltages
below 120VAC or 240VAC can result in less than rated ower and slower heating
times. This appliance is designed for holding food products only.
Note: For proper operation, an independent, dedicated circuit should be used
for up to 3 units installed on a 15amp (120VAC) circuit, 4 units installed on a
20amp (120VAC) circuit, or up to 5 units installed on a 20amp (240VAC)
circuit.
To operate all models:
● Press the Power button to turn the unit on. The green LED next to
the power button will illuminate. Press the Power button when you
are finished to turn the unit off.
● To lock the controls, press the Lock button three times. The
red LED to the right of the lock button will illuminate to indicate
the unit is locked. Locking the unit will prevent temperature
settings from being changed. The Power button will continue to function while
the unit is locked. To unlock the controls, press the lock button three more
times. Unplugging the unit when powered on will also unlock the unit.
● Press the Up and Down Arrows to select the desired temperature.
The default preset choices are:
● Fahrenheit Settings: 150, 160, 175, 190
● Celsius Settings: 65, 70, 80, 90
Additional temperature settings are available by changing the temperatre
settings option. See “Changing the Set Temperature Options” on page 6.
Note: When the unit is not in use for 5 minutes, it will enter a power save
mode where the Power LED will flash. Press any button on the controls to
exit the power save and return to the previous settings.
● Place an induction compatible pan on the unit.
● The letter “F” or “C” will flash in the display window and the Heating
LED will turn on.
● When the pan has reached the selected temperature, the “F” or “C” will stop
flashing and remain solid. The Heating LED will turn off and the At
Temp LED will turn on.
● The set temperature can be adjusted at any time while the pan is on
the unit by pressing the Up and Down Arrows.
● When a pan is removed from the unit, the Heating and At Temp LEDs will turn
off and the “F” or “C” will turn on solid in the display. The unit is not heating or
holding the set temperature when both LEDs are off.
● When finished using the unit, press the Power button to turn the unit off.
The Power LED will turn off. Remove then pan from the unit. The unit
will remember the last temperature setting the next time it is powered on.
ΠΡΟΕΙΔΟΠΟΙΗΣΗ: Ένα εσφαλμένα γειωμένο φις μπορεί να έχει ως
αποτέλεσμα την ηλεκτροπληξία. Παρακαλείστε να συμβουλευτείτε αρμόδιο
ηλεκτρολόγο εάν έχετε τυχόν ερωτήσεις σχετικά με αυτές τις οδηγίες
γείωσης.
Πριν ξεκινήσετε:
Βεβαιωθείτε ότι αυτό το ηλεκτρικό καλώδιο είναι σταθερά συνδεδεμένο στη μονάδα
CookTek σας ΠΡΙΝ συνδέσετε το φις της μονάδας σε ηλεκτρική πρίζα και πριν
προσπαθήσετε να θέσετε τη μονάδα σε λειτουργία.
● Μην αγγίξετε την κεραμική πλάκα (ή το άνω μέρος του Cooktop) αμέσως μετά
τη χρήση. Η θερμότητα από την κοιλότητα θα μεταφερθεί στην κεραμική πλάκα.
Ως εκ τούτου, αυτή θα είναι πολύ ζεστή για να την αγγίξετε.
● Οι εργασίες επισκευής του προϊόντος αυτού πρέπει να πραγματοποιούνται
μόνο από εξουσιοδοτημένο αντιπρόσωπο επισκευών ή από προσωπικό της
CookTek. Μην επιχειρήσετε να ανοίξετε τη μονάδα ή να εκτελέσετε οποιαδήποτε
εργασία επισκευής σε αυτήν. Για πληροφορίες σχετικά με τις επισκευές,
επικοινωνήστε με την CookTek στον τηλεφωνικό αριθμό 1-312-563-9600.
● Η συσκευή αυτή πρέπει να είναι γειωμένη. Συνδέστε μόνο σε σωστά γειωμένη
πρίζα. Πριν τη λειτουργία, διαβάστε τις οδηγίες γείωσης και τις απαιτήσεις
ηλεκτρικής εγκατάστασης στη σελίδα 3 του παρόντος φυλλαδίου. Μη
χρησιμοποιείτε καλώδιο προέκτασης (μπαλαντέζα).
Prima di mettere in funzione il piano cottura, eseguire le seguenti operazioni:
● Rimuovere tutto il materiale di imballaggio.
● Collocare l'unità su una superficie asciutta, piana, rigida, stabile e non
infiammabile.
● Tenere l'unità lontana da altre fonti di calore e lasciare almeno 5 centimetri di
spazio per consentire la circolazione dell'aria tutto intorno all'unità.
Per la propria sicurezza, non tagliare, rimuovere o disattivare mai il collegamento
elettrico di terra dalla spina. Non utilizzare mai una spina adattatore o un cavo
elettrico di prolunga per collegare il piano cottura.
AVVERTENZA: una spina elettrica non correttamente collegata all'impianto di
terra può provocare scosse elettriche. Rivolgersi a un elettricista qualificato
in caso di domande su queste istruzioni di messa a terra.
Prima di iniziare:
Assicurarsi che questo cavo di alimentazione sia collegato saldamente all'unità
CookTek PRIMA di collegare l'unità alla presa elettrica e prima di metterla in
funzione.
● Non toccare la piastra di ceramica (o la superficie del piano cottura) subito dopo
l'uso. Il calore della pentola si trasferisce alla piastra di ceramica, rendendola
estremamente calda.
ITALIAN
Manual IHW 14049_A USINTL
SMARTEMP™ OPERATION
GENERAL OPERATION