Instructions / Assembly

QUICK START – WIRELESS CONTROL MODELS

1. Determine Location

Find a location in a center hallway or similar area and mark the

center of the ceiling with a pencil. Drill a hole through the ceiling

and push a marker through so it can be located in the attic.

2. Prepare Shutter Opening

Find the joist closest to the hole and mark out an area equal to the

size of the inner edges of the shutter with the joist in the center.

Remove all insulation from the area before cutting. (Figure 1)

3. Cut the Shutter Opening

Use a circular saw or saber saw to cut along the marked area of the

ceiling then carefully remove the drywall from the opening.

(Figure 2)

4. Frame and Facing

Use lumber of the same dimensions as your joists and fasten them

to the edges of the frame opening using #12D nails to create a

complete square frame then replace the insulation around the

frame. (Figure 3) Then use 2 X 6 boards to create a square rest

with the inside dimensions being the same as the opening. (Figure

5. Installing the Fan

Assemble the fan properly, as pieces were moved to protect them

during shipping, and take it up to the attic. Place the fan on top of

the facing and nail it in. (Figure 5)

6. Installing the Shutter

Draw alignment marks 7/8” away from the edges then install the

shutter with the white-headed wood screws provided with the fan.

(Figure 6)

7. Wiring Instructions

After disconnecting the power supply attach the wires as shown.

(Figure 7)

8. Hub Pairing Instructions

Download the Wi-Fan app available at your smart device store and

follow the in-app instructions to begin the pairing process.

Figure 1

Figure 2

Figure 3

Figure 4

Figure 5

Figure 6

Tools and Materials Needed

 Drill • 1/4” and 1/8” drill bits • Straight edge ruler

 Pencil or marker • Circular saw • 1 1/2” ring shank drywall nails

 #12D nails • Adjustable wrench • Flat head screwdriver

 Philips head screwdriver • Safety goggles • Saber saw

 Speed square

Figure 7