USBG-410B User Manual
Table of Contents Chapter 1 Introduction ……………………………………………… 1.1 Product features and Specifications ……………………. 2 2 Chapter 2 Installation ………………………………………. 3 2.1 Product/Package Checking List …………………………………. 3 2.2 Installing USBG-410B …………………………………………………. 4 2.2.1 Installing Hot-swap Hard Disk Drive ……………... 4 2.2.2 To Operate ………………………………………….
Chapter 1 Introduction. USBG-410B is a high speed USB (USB2.0) application. It provides a solution for low cost, high performance and support USB 2.0 (480mbps) interface; USBG-410B will bring the convenience of data back up ability by USB interface. 1.1 Product Features and Specifications Specifications: Host Interface USB 2.
Chapter 2 2.1 Installation Product/Package Checking List Before install this product please make sure you have the following items: Enclosure x 1 Stand x 1 HDD Tray x 2 USB Cable x 1 Power Adapter w/ Power Cord x 1 Driver/Manual CD-ROM x1 Hard Disk Drive mounting screw x 8 Key for HDD tray x 2 2.2 Installing USBG-410B 2.2.1 Installing Hot-swap Hard Disk Drive USBG-410B has two hot-swap drive bays, and can install two 3.
x Ultra ATA133 Cable Power Cable 4 HDD Screw Figure 2.2.1 2.2.2 To Operating a. Connection USB cable from Host to USBG-410B b. Connection power Adapter c. Power Switch set to AUTO The Power will ON/OFF Automatically switching According to the Host USB Power. If Power Switch set to OFF the USB HUB still can working but Host cannot access the HDD on NA410B * Please refer to figure 2.2.
Power SW USB In Power In USB Out Figure 2.2.
FCC Class B Radio Frequency Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.