Specifications

Connecting an additional unit to increase the output (Stereo Link)
By connecting two MR2 units you can create a stereo PA system with greater output power.
This function is called “Stereo Link.”
You can connect Stereo Link in either of the following two ways.
If using the input jacks of only one of the units
Use one cable with a 1/4” phone plug and RCR for another side.
If you want to use the input jacks and output XLR of both units
Use two cables having 1/4” phone plugs and RCR for another side
External Speaker
By connecting two MR2 units external speaker, 1/4" jack provides the powered signal from
the amplifier. Use this jack to add a second speaker cabinet in parallel. The external minim-
um speaker load impedance is 8 ohms. you can create a stereo PA system with greater out-
put power
MR 2 SPECIFICATIONS
PREAMP SECTION
The following preamp specs are measured @ 1 kHz‚ nominal signal levels are with channel
level controls set at 5‚
minimum levels are with channel level controls set at 10.
Channel 1 Inputs:
Input Impedance: 100 k‚ Nominal Input
Nominal Input Level: -22 dBV‚ 79 mV RMS
Minimum Input Level: -40 dBV‚ 10 mV RMS
Channel 2 Input:
Low Z Input Impedance: 5K Ohms
Nominal Input Level: -28 dBV‚ 40 mV RMS
Minimum Input Level: -48 dBV‚ 4 mV RMS
High Z Input Impedance: 100 k‚
Nominal Input Level: -5 dBV‚ 560 mV RMS
Minimum Input Level: -22 dBV‚ 79 mV RMS
Headphone Output
Load Impedance: 8 Ohms or greater
Nominal Output: 100 mW RMS
Main Line Out
Output Impedance: <100