Full Product Manual

9
6.1 Troubleshooting (continued)
Pump
Problem
Check
Solution
Pump motor will not run when
switch is turned on.
Turn fan on to check for power.
Is water level high enough to
make the low- water cut-off
circuit?
If fan doesn’t start; check
breaker and cord plug-in. If fan
does start; check for power to
and through pump switch (when
turned on). Fill water reservoir.
Pump motor hums when switch
is turned on, but does not pump
water.
Obstruction in impellor.
Pump motor failure.
Remove object(s).
Replace pump.
Pump makes loud noise while
running.
Object(s) in impellor, impellor
loose. Pump bearings bad.
Remove object(s).
Replace pump.
Breaker trips or fuse blows when
switch is turned on.
Check power cord length and
breaker rating.
Check for locked-up pump.
Refer to page 2 for unit
amperage draw and to
determine required cord gauge.
Replace pump.
Pump won’t run and power is
available. Pump is functional.
Make certain switch is working.
Is water level high enough to
make the low- water cut-off
circuit?
Replace switch if not completing
circuit. Fill water reservoir
enough to activate Low Water
Shut-off switch.
Pump runs but does not pump
water.
Air lock in outlet side of pump.
Make certain the impellor is
turning in pump.
Turn off and on to bleed.
If not, replace pump.