Product Manual
Table Of Contents
- INSTRUCTION AND MAINTENANCE MANUAL
- CONTENTS
- ATTENTION: THERE IS A COPY OF THE WIRING DIAGRAM INSIDE THE ELECTRIC PANEL
- CHARACTERISTICS AND SAFETY PRECAUTIONS
- AIR OUTLET
- AIR INLET
- CONDENSATE DRAIN
- FIG. 2
- C 7,5 ÷ 10
- C 7
- FIG. 3
- FIG. 4
- FIG. 6
- FIG. 7
- (A) AIR INLET
- (B) AIR OUTLET
- ELECTRICAL CABLE
- CONDENSATE DRAINING
- Nominal
- Nominal
- Weight
- C 125
- FIG. 8
- FIG. 9
ENGLISH
8 - Edition 08/2014 Cod. 2200791683 01 -
14.2 COMMAND AND CONTROL PANEL
BEFORE CARRYING OUT THE OPERATION TEST, READ CAREFULLY AND ACQUIRE A GOOD KNOWLEDGE OF THE COMMAND
FUNCTIONS.
Ref. 1) Dew point indicator
Ref. 2) Stop - Running button
15.0 PARTIAL ROUTINE MAINTENANCE
BEFORE CARRYING OUT ANY MAINTENANCE JOBS IT IS OBLIGATORY TO STOP THE MACHINE AND DISCONNECT IT FROM THE
POWER MAINS AND FROM THE COMPRESSED AIR DISTRIBUTION NETWORK.
15.1 MAINTENANCE SCHEDULE
These maintenance intervals are recommended for work environments that are not dusty and are will ventilated. For
particularly dusty environments, double the frequency of controls.
Each Week
Condensate drain: Clean the filter of the steam trap
Each Monthly
Condenser: Clean the condenser fins to remove eventual dust.
15.2 CLEANING OF THE AUTOMATIC CONDENSWATER DISCARGER FILTER (Fig. 10)
Clean the filter of the steam trap.
Proceed as follows:
- Close the cock Ref. 1 Fig. 10
- Release the pressure in the dryer by pressing the condensate drain “TEST” pushbutton locate on the
steam trap
Ref. 2 Fig. 10.
- Switch off the machine by pressing the STOP button Ref. 3 Fig. 10
- Turn on the supply automatic differential switch Ref. 4 Fig. 10
HOT PARTS INSIDE
- Remove the panels Ref. 5
- Remove the stopper Ref. 6
- Remove the filter Ref. 7
- Clean the filter Ref. 5 with a jet of air, working from inside to outside
- Install the filter, fix the plug Ref. 7 - 6
- Close the panels Ref. 5
FIG. 9
1
2
1
FIG. 10
4
3
5
6
7
2