Installation Guide

PREPARE CRANK UNIT FOR AN INSIDE

VERTICAL MOUNT

A. Start by sliding oﬀ the bracket cover on the

Crank unit if installed (Fig. 13).

B. Remove the four screws from the Crank unit.

C. Rotate the Crank unit 90° so the wand eyelet

hangs straight down to the ground if the bracket

were hanging from the inside mount (Fig. 14).

D. Put screws back in. You will not need the bracket

covers.

INSTALL SHADE

A. Insert the Clutch plug into the Crank unit

(Fig. 16).

B. Then insert the Idle end plug into the Idle end

unit, and snap the Idle end plug securely into place

(Fig. 17).

Fig. 13

Fig. 14

Fig. 15

Fig. 16

Fig. 17

Installing Inside Top Mount

Brackets facing down

INSTALL CRANK UNIT, IDLE END UNIT AND

VALANCE

A. Mark the holes where you are going to put your

screws.

B. Attach valance to Crank unit and Idle end unit

through holes in top of valance or sandwich the

valance between the top of window casing and the

brackets.

NOTE: Hardware to attach valance to Clutch

and Idle end unit is not provided.

C. Install the Crank unit and Idle end unit using

screws provided (Fig. 15).