Installation Guide

2
Your Shade comes standard with the Clutch on the
right side of the Shade and ready to be mounted on
the inside or outside of your window frame. If you
purchased a custom Shade, or intend to keep your
Shade with the standard settings, you may skip this
section and proceed to the installation instructions.
If you want to move the Clutch to the le side of the
Shade or you want to hang your Shade from the top of
the window (or ceiling), you will need to make a few
simple changes to your Shade before proceeding to the
installation instructions.
IMPORTANT: The screws included in your
hardware kit are for use with wood only. See your
retailer for mounting recommendations when
attaching your Shade to any other material.
Snap Idle end plug
into Idle end unit
Clutch plug
Remove
screws to
change from
right hand
to le hand
control
Rotate Crank
unit 180°
Fig. 2
Fig. 3
Fig. 4
Fig. 5
B. First, insert the Clutch plug into the Crank unit (Fig. 2).
C. Insert the Idle end plug into the Idle end unit, and
snap the Idle end plug securely into place (Fig. 3). With
the Shade in place, adjust the brackets so they fit snugly
on each end of the Shade.
IMPORTANT: Now go back and tighten the bracket
screws completely.
ALTERNATIVE CLUTCH SETUP
Your Shade will require a non-standard installation if:
you are changing the Clutch to the le side of the
Shade, or if you are mounting your Shade from the
top/ceiling.
NOTE: If you purchased a custom Shade or are
doing a standard installation, you do NOT need
to make these changes.
A. If you want your Clutch to be on the le side of
your Shade, you will need to make a simple change
to your Crank unit before you install your Shade. To
make this change, remove the four screws (Fig. 4).
B. Turn the Crank unit 180
° so the wand eyelet can
now hang down from the le side (Fig. 5).
C. Put the screws back in, and tighten. No change
is needed to the Idle end unit, it works for right and
le mounts.
3