i. CAUTION FOR SAFETY. 1. Leave enough space from the wall to the cabinet and the ceiling; do not be sealed completely in the back part of the cabinet, prepare an air vent to the outside. Caution:it needs more than 20 ¢m from the cabinet to wall. 2. Pisase nave away all out-packages for bottom heat radiation to waylaid fire. 3.it's prohibited to store flammable and volatile chemical or leading to exploding. 4. individual single-phase socket must be used. lt should be reliably connected to a grounding wire.
INSTALLATION IMPORTANT! PLEASE READ BEFORE INSTALLATION 8 [f the unit has recently been transported, please let unit stand still fora minimum of 24 hours before plugging tin, 8 Make sure that the unit drops down to desired temperature before loading the unit with product. B Make sure that there is proper ventilation around the uniting the area where it will operate. B Make sure all accessories are installed(i.e shelves, shelf clips, casters) before plugging the uniting.
with appropriate over current protection. Please refer to the electrical requirements on the nameplate. Please make sure that your unit has its own dedicated outlet. Do not use an extension cord. SAFETY / WARNING Please pay close attention to the safely notices in this section. Disregarding these notices may lead to serious injury and/or damage to the unit. ATTENTION B® To minimize shock and fire hazards, be sure not to overload outlet. Please designate one outlet for your unit.
B Do not attempt to taller or tamper with the electrical cord. REGULAR MAINTENANCE CLEANING THE CONDENSER COIL B For efficient operation, it is important that the condenser surface be kept freak of dust, dirt, and lint. B We recommend cleaning the condenser coil and fins at least once per mart. | Clean with a commercial condenser coil cleaner, available from any kitchen equipment retailer. Brush the condenser fins from top to bottom, not side to side.
TROUBLE SHOOTING Before requesting any service on your unit, please check the following points. Please note that this guide serves only as a reference for solutions io common problems. SYMPTOM | POSSIBLE CAUSE CORRECTIVE ACTION Compressor Fuse blown or circuit breaker tripped. | Replace fuse or reset circuit not running. breaker. Power cord unplugged. Plug in power cord, Thermostat set foo high. Thermostatic to dower temperature, Cabinet in defrost cycle. Wait for defrost cycles to finish.
Evaporator coil ied over. for long periods of ime. {see above) Cabinets noisy. Loose part(s). Tubing vibration. Vacate and tighten Bose part(s). Ensure tubing is free from contact with other tubing of components.
