Coolest MANUAL & SAFETY INSTRUCTIONS
WARNINGS & WARNING To reduce the risk of fire, burn hazard or otherinjury, read this safety manual carefully and completelybefore using this appliance. & Do not store spare LP-gas cylinder under or near the appliance. Never fill the cylinder beyond 80 percent full. Before cleaning, make sure the gas supply and control knob is in the OFF position and that the burner and oven has cooled.
The parts which have been sealed by the manufacturer should not be adjusted by the user • Whenthe appliance is using LPG A LPG cylindershould be used The LPG cylinder size: max diameter-350mm, max height-400mm. • The appliance is to be installed with sufficientventilation to prevent the occurrence of unacceptable concentrations of substances harmful to health in the room in which the appl iance is install ed • The minimum distances between the appliance and adjacent walls is 0.
3. Connecling gas hose lo P200 Depending on your region the hose may be preassembled. 4. Connecting to gas tank & 3a. Connecling gas hose directly lo P200 WARNING Please always keep the gas bottle in upright positi on. • The size for 20 lbs LP gas cylinder is 12.2 inches in diameter and 17.9 inches tall Il the applian ce is not in use. the gas must be turned off al the supply cylinder. • The cylinderused must include a collar l o protect the cylinder valve.
LEAK TESTING OPERATING INSTRUCTIONS GENERAL USING THE OVEN Although the gas connections of the appliance are leak tested prior packing and shipment. a completetest must be performed at the installa tion site. Before each use, check all the gas connections for leak testing using the procedure listed below.lf the smell of gas is detected at any time, you should imm ediatelystop using and check the entire system for teaks. Each burner is rated at 4.0KW. To begin: 1.
TROUBLESHOOTING 8 Problem Possible Cause Prevention/Solution Burner will not light 1. No gas flow 2. Coupling nut and regulator not fully connected 3. Obstruction of gas flow 4. Disengagement of burner to valve 5. Incorrect assembly 1. Check to see if propane tank is empty 2. Turn the coupling nut about one-half to three quarters additional turn until solid stop. Tighten by hand only - do not use tools 3. Clear burner tube 4. Reengage burner and valve 5.
